Dell PowerConnect M8024-k Konfigurationshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Konfigurationshandbuch für Schalter Dell PowerConnect M8024-k herunter. Dell PowerConnect M8024-k 21 Seiten. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Auch für Dell PowerConnect M8024-k: Anmerkungen zur Veröffentlichung (27 seiten), Aktualisieren der Firmware (24 seiten)

Seite drucken

Dell PowerConnect M8024-k Konfigurationshandbuch

2.2

Hardware configuration

Power on the two switches.

2. Connect a serial cable to the serial port of the first switch.

3. Using Putty or another terminal utility, open a serial connection session to the switch.

4. Open your terminal emulator and configure it to use the serial port (usually COM1, but this may vary

depending on your system). Configure serial communications for 9600,N,8,1 and no flow control.

5. Connect the LAG cables between the switches. See this configuration in Figure 1.

2.3

Check firmware version

console>enable

console#show version

Note: If the active version displayed here is not 5.1.1.7 or later, please visit support.dell.com and

download the latest update for your switches.

2.4

Delete startup configuration

Note: All configuration settings will be deleted.

console#clear config

console>enable

console#copy running-config startup-config

console#reload

Are you sure you want to reload the stack? (y/n) y

Note: The switch will reboot.

2.5

Disable DCB

Note: The PowerConnect 8024 and 8024F switches do not support Enhanced Transmission Selection

(ETS), therefore Data Center Bridging (DCB) must be manually disabled using the following steps:

console>enable

console#configure

console(config)#no dcb enable

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs