Dell PowerEdge 2550 Anweisungen zur Rack-Installation - Seite 11

Blättern Sie online oder laden Sie pdf Anweisungen zur Rack-Installation für Schalter Dell PowerEdge 2550 herunter. Dell PowerEdge 2550 40 Seiten. Wake-on-lan (wol) support on dell servers
Auch für Dell PowerEdge 2550: Installationshandbuch (26 seiten), Handbuch installieren (32 seiten), Konfigurationshandbuch (10 seiten), Aktivierungshandbuch (32 seiten), Installationshandbuch (32 seiten), Handbuch (28 seiten), Handbuch (15 seiten)

F i g u r e 1 - 3 . Tw o - P o s t , O p e n - F r a m e R e l a y R a c k W i t h W i d e - H o l e S p a c i n g

3.5 inch (2 U)

CAUTION: The 2-U support tray is designed to support a single system in a

2 -post open frame relay rack. Do not attempt to install any other system in this

support tray. Damage to the system and personal injury to you and others may

result.

Flush-Mount Installation

This procedure uses the same support tray kit, but it does not use the center-mount

brackets.

Place the support tray into the rack with the bottom of the tray at the marks you made

in step 4 (for a universal-hole spacing rack) or in step 5 (for a wide-hole spacing rack)

in the section, "Marking the Rack." The center-mount brackets, the 10-32 x

0.375-inch truss-head screws, and the #10 internal-star washers are not used when

mounting the support tray's front mounting bracket flush against the 2-post rack.

If you are installing the support tray in a rack with universal-hole spacing, install four

12-24 x 0.5-inch pan-head Phillips screws to secure the support tray using the upper

and lower holes that you marked on the rack's front surface (see Figure 1-4).

An internally threaded stud projecting from the front of the tray flanges accepts the

captive fasteners on the front panel of the system.

1.75 inch (1

0.5 inch

1.25 inch

Ra c k In s ta l lati on Gui de

1-5