AVX AVX-BTA-3000 Gebrauchsanweisung - Seite 6
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Lautsprechersystem AVX AVX-BTA-3000 herunter. AVX AVX-BTA-3000 7 Seiten. Bluetooth stereo hi-fi system
Seite drucken
Additional Information / Troubleshooting
*Please refer to the chart below if your amplifier is not functioning properly. In the event
you are experiencing an issue not outlined below, please contact an authorized AVX Audio
dealer to obtain further support.
PROBLEM
CAUSE
The power cable is not
THE UNIT
connected or the plug
FAILS TO
is not completely inserted.
TURN ON
Protection Circuitry has
been activated because of
a short circuit.
NO SOUND
Incorrect output or input cable
connections
Speaker A/B selector is not
set properly.
Speaker output has been muted.
The connected component
is not playing.
SOUND
The unit has become too hot
SUDDENLY
and has gone into protection
GOES OFF
mode.
Amplifier has turned off
THERE IS
Speakers are connected out
A LACK
of phase / + and - is reversed
OF BASS
REMOTE
CONTROL
The batteries are weak or
DOES NOT
not inserted
FUNCTION
PROPERLY
REMEDY
Connect the power cable firmly
Check and confirm speaker
wires are not touching and
then turn power back on.
Verify cables are connected
properly, if problem persists
cables may be defective
Confirm Speaker A/B selector
is set to the appropriate output
that speakers are connected to
Disable the mute function.
Verify component is connected
to the corresponding input
that is being selected.
Make sure the openings on
the top panel are not covered.
Allow unit to cool.
Verify speaker connections
are not touching one another.
This will cause a short circuit.
Connect the speaker wires to
the correct + and - phase.
Replace all batteries.
5