Dell PowerEdge XL 5133-4 Handbuch "Erste Schritte - Seite 22

Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Schalter Dell PowerEdge XL 5133-4 herunter. Dell PowerEdge XL 5133-4 38 Seiten. Dell poweredge m i/o aggregator getting started guide

Seite drucken

1. Internal Ports

Before You Start

Before you reconfigure default settings, ensure that:

•

The Aggregator booted successfully when it powered on.

•

The console connection is established and the login prompt appears on the

screen of a VT100 terminal or terminal equivalent.

By default, the Aggregator receives the following IP addresses from a DHCP

server in the network. If you want to change the DHCP default setting, obtain

the required information from your network administrator, such as:

•

The IP address and subnet mask of the out-of-band interface used for

remote management via Telnet, SNMP, or other management agents.

•

The IP address and subnet mask of the default VLAN IP address used for

in-band management.

•

The IP address of the default gateway used for IP access to the Aggregator.

Reconfiguration Using the CMC Interface

For information about how to access the CMC to configure an Aggregator,

Dell Chassis Management Controller (CMC) User's Guide

refer to the

the Dell Support website at

http://support.dell.com/support/edocs/systems/pem/en/index.htm.

online help provides information about how to use the Web interface. The

default settings that you can change using the CMC interface are noted in

the CLI reconfiguration procedure below.

Reconfiguration Using the CLI

To reconfigure any settings in the default Aggregator configuration using the

CLI:

1 (CMC-supported) From the console monitor or a remote management

session, log in by entering the user ID "root" and password "calvin". Then

press Enter.

Password: *****

FTOS>

Installing and Configuring the Aggregator

The CMC