Dell S3100 Series Handbuch "Erste Schritte - Seite 26

Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Schalter Dell S3100 Series herunter. Dell S3100 Series 46 Seiten.
Auch für Dell S3100 Series: Installationshandbuch (45 seiten), Handbuch "Erste Schritte (27 seiten)

Seite drucken
Dell S3100 Series Handbuch

Installation

This information describes unpacking a S3100 series switch, installing the power supplies, and mounting
the switch in your rack. Optional procedures such as connecting the stacking ports or installing a plug-in
module are also described.

Unpacking a S3100 Series Switch

To unpack your switch, follow these steps.
NOTE: Before unpacking the switch, inspect the container and immediately report any evidence of
damage.
When unpacking each S3100 series switch, make sure that the following items are included:
•
One S3100 series switch.
•
One RJ-45 to DB-9 female cable.
•
One Dell ReadyRails™ kit for rack installation, two mounting brackets, bolts, and cage nuts.
•
One set of self-adhesive rubber pads for free-standing installation (four pads are included).
•
One PSU.
•
Getting Started Guide.
•
Safety and Regulatory Information.
•
Warranty and Support Information.
•
Software License Agreement.
1.
Place the container on a clean, flat surface and cut all straps securing the container.
2.
Open the container or remove the container top.
3.
Carefully remove the switch from the container and place it on a secure and clean surface.
4.
Remove all packing material.
5.
Inspect the product and accessories for damage.

Installing a Power Supply

To install a power supply, follow these steps.
CAUTION: Remove the power cable from the power supplies prior to removing the power supply
module itself. Power must not be connected prior to insertion in the chassis.
CAUTION: To prevent electrical shock, ensure that the system is grounded properly. If you do not
ground your equipment correctly, excessive emissions may result. To ensure that the power
cables meet your local electrical requirements, use a qualified electrician.
WARNING: ESD damage can occur if components are mishandled. Always wear an ESD-
preventive wrist or heel ground strap when handling the system and its components.
26
3
Installation