Dell S4100-ON Series Setup-Handbuch - Seite 18
Blättern Sie online oder laden Sie pdf Setup-Handbuch für Schalter Dell S4100-ON Series herunter. Dell S4100-ON Series 21 Seiten.
Auch für Dell S4100-ON Series: Installationshandbuch (47 seiten), Installationshandbuch (48 seiten), Installationshandbuch (49 seiten)
Seite drucken
Optics removal
Remove an optic by pushing the tab on the optic and sliding the optic from the port.
When removing optics with direct attach cables (DACs) from the port, pull the release tab firmly and steadily. Before pulling the release tab,
you may need to gently push the optic into the port to ensure that it is seated properly. Do not jerk or tug repeatedly on the tab.
System power-up
Supply power to the S4100–ON Series switch after you mount it in a rack or cabinet.
Dell recommends reinspecting your system before powering up. Verify the following:
•
The equipment is properly secured to the rack. Dell recommends properly grounding the switch.
•
The ambient temperature around the unit, which may be higher than the room temperature, is within the limits specified for the S4100–
ON Series, see Specifications.
•
There is sufficient airflow around the unit.
•
The input circuits are correctly sized for the loads and that you use sufficient overcurrent protection devices.
•
All protective covers are in place.
•
Blank panels are installed if you do not install optional modules.
CAUTION:
Do not power up the switch if you did not install a fan module.
NOTE:
A US AC power cable is included for powering up an AC power supply. You must order all other power cables separately.
NOTE:
ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when
handling the S4100–ON Series switch and its components.
Power up sequence
When the switch powers up, the fans immediately come on at high speed. The fan speed slows as the system continues to boot up.
After system installation
To configure your system, after you have securely installed and powered on the S4100–ON Series switch, see your open network
installation environment (ONIE)-compatible operating system documentation at www.onie.org.
18
S4100–ON Series installation