Dell Z9100-ON Installationshandbuch - Seite 34

Blättern Sie online oder laden Sie pdf Installationshandbuch für Schalter Dell Z9100-ON herunter. Dell Z9100-ON 43 Seiten. Open networking
Auch für Dell Z9100-ON: Installationshandbuch (45 seiten), Installationshandbuch (45 seiten)

Seite drucken

The ONIE Install environment uses DHCP to assign an IP address to the management interface (eth0). If

that fails, it uses the default IP address 192.168.3.10/255.255.255.0.

To display the IP address, use the ifconfig eth0 command, as shown in the following example.

ATTENTION REVIEWERS:

Is this output still correct?

ONIE:/ # ifconfig eth0

eth0 Link encap:Ethernet HWaddr 90:B1:1C:F4:9C:76

inet addr:10.11.53.33 Bcast:10.255.255.255 Mask:255.0.0.0

inet6 addr: fe80::92b1:1cff:fef4:9c76/64 Scope:Link

UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

RX packets:18 errors:0 dropped:0 overruns:0 frame:0

TX packets:24 errors:0 dropped:0 overruns:0 carrier:0 collisions:0

txqueuelen:1000

RX bytes:1152 (1.1 KiB) TX bytes:6864 (6.7 KiB)

Interrupt:21 Memory:ff300000-ff320000

To assign an IP address to the management interface (eth0) and verify network connectivity, use the

ifconfig eth0 <ip address> command, as shown in the following example.

ONIE:/ # ifconfig eth0 10.11.53.33/16

Verify the network connection with ping.

ONIE:/ # ping 10.11.8.12

PING 10.11.8.12 (10.11.8.12): 56 data bytes

64 bytes from 10.11.8.12: seq=0 ttl=62 time=1.357 ms

64 bytes from 10.11.8.12: seq=1 ttl=62 time=0.577 ms

Management Ports