EarthPulse v.5 Pro Schnellstart-Handbuch - Seite 3
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Körperpflegeprodukte EarthPulse v.5 Pro herunter. EarthPulse v.5 Pro 7 Seiten.
Auch für EarthPulse v.5 Pro: Handbuch (12 seiten)
Seite drucken
You'll notice LCD screen lights momentarily as power is connected.
If not, check wall outlet.
4) Firmly plug electromagnet(s) into remaining jack(s).
Please familiarize yourself with
electromagnet schematic
diagram
so there is no confusion removing cross-polarity-ring, core & base-
plate for the initial session to be done with Air-Core magnet only.
5) Remove Electromagnet CROSS-POLARIZING ring so your mag-
net(s) look like the
on next page with
cross-polarity-ring removed.
6) Press ON/OFF button; CONTROLLER boots to RECOVER
-
ER again and press SELECT/START to select RECOVER; LCD then
displays TIME-REMAINING 8 Hours.
8) UP/DOWN arrows adjust TIME setting in 15 minute increments;
Set time now for 1 hour, or up to 3 hours. Press SELECT/START
Blue diode blinks in time with magnetic pulse. Controller is now ac-
tive at 70% amplitude.
9) UP/DOWN arrows adjust AMPLITUDE in 10% increments (only
while active and blue diode is blinking). Controller boots to 70% am-
plitude or approximately v.4.7 amplitude. Let your inner self guide you
on knowing how much amplitude is comfortable during initial session
on how you feel. Some will feel 50% is enough during initial session.
A small percentage of users are sensitive to EMF even at these low
10) SELECT/ENTER BUTTON becomes RESET button when AC-
TIVE MODE; press during runtime and see controller reboots to RE-
COVER allowing new program choice without turning off. UP/DOWN
arrows are amplitude control during runtime.
BACK TO TABLE OF CONTENTS:
2