EarthQuake MiniMe DSP P10 Benutzerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Subwoofer EarthQuake MiniMe DSP P10 herunter. EarthQuake MiniMe DSP P10 19 Seiten.
Seite drucken
Connecting Your Subwoofer(s)
Low Level Setup - Single Sub
This is the best way to drive an audio signal into the
MiniMe DSP P10/P12. Today, all signal processors
(5.1/6.1 and more advanced ones) come equipped
with built-in pre-amplifier outputs (RCA) that include
a subwoofer output. Generally, the SUB PRE OUT is
in mono format. Connect the SUB PRE OUT from the
processor/receiver to the MiniMe DSP P10/P12's
LOW LEVEL INPUT using a "Y" RCA cable.
We strongly recommend that you use the best
available RCA connectors and cables. High quality
cables are normally triple shielded and the
connectors are gold plated with forceful grasping.
When using this connection, the MiniMe DSP
P10/P12 only receives bass signals from the source.
Therefore, the crossover frequency should be set at
max value.
Low Level Setup - Dual Sub
For a more realistic sound stage and greater theater
experience, we suggest having two (2) subwoofers
and running them in stereo.
Using a "Y" RCA cable, connect the SUB PRE OUT 1
of the receiver to the LOW LEVEL INPUT of the left
side MiniMe
DSP P10/P12
.
Using another "Y" RCA cable, connect the SUB PRE
OUT 1 of the receiver to the LOW LEVEL INPUT of
the right side MiniMe
DSP P10/P12
In case the subwoofers become out of phase with the
main front speakers, flip the phase switches to
correct the problem. Note that maximum bass is only
achieved when the sub is in phase with the speakers
in your system.
10 MiniMe DSP P10/P12
NOTE:
.
PRE OUT (SINGLE)
FRONT
SURROUND
MONO
DSP
Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com
PRE OUT (SINGLE)
back of typical
processor/receiver
FRONT
SURROUND
SUR. BACK
D
O
NOT
USE HIGH LEVEL AND
LOW LEVEL INPUTS AT THE SAME
TIME
back of typical
processor/receiver
SUR. BACK
SUB
CENTER
SUB
CENTER
MONO
DSP
MONO
DSP