EarthQuake Cinenova 7 Benutzerhandbuch - Seite 16

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken EarthQuake Cinenova 7 herunter. EarthQuake Cinenova 7 20 Seiten.

EarthQuake Cinenova 7 Benutzerhandbuch
Cinénova 7 Front Panel Overview
Rear Panel of Cinénova 7
1
2
RF
RCA
INPUT SELECTOR
XLR
MAX
MIN
SPEAKER OUTPUT
7
16
3 4
5
6
GND +12V
USE ONLY WITH A 250V FUSE
AC110V/60Hz
1. RCA Input:
Accepts low-level signal from any source, such as a processor or receiver. From 0.4
Vac up to 6 Volt AC.
2. Input Selector:
To maintain signal integrity Cinénova-7 provides you with an "Input Selector
Switch". This gives you (installer) the option to select between RCA or XLR
inputs.
3. Fully Balanced XLR Inputs:
We recommend the use of fully balanced XLR inputs in cases when the distance
between the Cinénova and the audio source is excessive and susceptible to noise
interference.
4
. Gold Plated Speaker
Output Binding Posts:
We recommend that you use a high quality wire constructed of fine, multi-strand
copper 10-gauge and up. Wire with a gauge of 16 may be used for short runs of less
than twenty feet. We do not recommend that you use any wires with a gauge
equivalent of 18 or higher due to the power loss and performance degradation.
5.
12VDC Trigger:
In order for the Cinénova Turn-ON to be controlled via another source, connect the
12VDC trigger input to the 12VDC source output (polarity is not an issue). From
your source, 12VD should have over 20mA. Then set the manual power switch to
OFF and the circuit breaker to ON. Now any time the Cinénova detects an incoming
12VDC signal it will automatically power on.
6.
AC Input Connector:
IEC Power Receptacle
7.
Input Sensitivity:
Input selector gain set is based on your processor output voltage. The table
shown below reflects the signal required from your processor if you were to set
this gain based on the displayed position.
Signal
Signal
Signal
Signal
required
required
required
required
6 Volts
5 Volts
4 Volts
3 Volts
Earthquake Sound
Signal
Signal
Signal
Signal
required
required
required
required
2 Volts
1.5 Volts
1 Volts
0.75 Volts
specifications are subject to change without notice
Signal
Signal
required
required
0.5 Volts
0.4 Volts