32 Degrees Icon-E Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Paintball-Ausrüstung 32 Degrees Icon-E herunter. 32 Degrees Icon-E 6 Seiten.

Seite drucken

Welcome . . .Thank you for purchasing the Icon Electronic Paintball marker. The Icon-E

represents the culmination of a great deal of research by 32 Degrees, along with input

from players such as you. We believe that the affordability of a reliable, feature-packed

marker will improve your playing experience and winning percentage. While winning

isn't everything, it sure beats the alternative!

Play hard, play safe, play to win!

WARRANTY INFORMATION

Standard Warranty:

The manufacturer warranties to the original customer that this product is free from defects in

material and workmanship under normal use and service for a period of 90 days from the

original date of purchase by the initial owner/purchaser. The manufacturer agrees to repair or

replace (at its discretion) any product within a reasonable period of time. This warranty does

not cover: o-rings, scratches, nicks, normal wear and tear of parts, any modifications or

normal fading of anodizing or damage caused by dropping or hitting of the product. This war-

ranty shall not apply if it is shown by the manufacturer that the consumer caused the defect

or malfunction because of misuse. This warranty only covers original factory parts. Any modi-

fications or tampering of original factory parts will not be covered by this warranty. Warranty

work can only be conducted by the manufacture technicians and or authorized technicians.

If product needs to be repair, package it carefully and send it together with your name,

address, phone number and a brief description of the malfunction to: Paintball Solutions

Extended Warranty:

By returning the enclosed warranty registration card or registering your warranty on-line at

www.PaintballSolutions.com, within fifteen days of purchase the warranty will automatically

be extended for an additional year.

570 Mantua Blvd

Sewell, NJ 08080

Initial Assembly

1. Screw the barrel (#23) hand tight into the Main Body (#34).

2. Screw the Velocity Adjuster (#12) into the Hammer Plug (#24) approximately two

complete turns.

3. Place a Barrel Plug or Barrel cover into/on the end of the barrel. The barrel is the top

chamber of the Main Body (#34).

Battery Installation

1. Find the safety switch located on the left side of the marker just above the Left Grip

Panel (#36).

2. Make sure the switch is in the "Safety" position (toward the rear of the marker).

3. Using a screwdriver, remove the three Grip Panel Screws (20) from the left side (side

facing you if the barrel is pointing to your left) of the Grip Panel (36).

4. Install the 9-volt battery.

NOTE: We recommend the use of a strong, brand name battery, such as Duracell or

Energizer, for a longer lasting charge and better performance.

5. Push the safety switch towards the on position (toward the front end of the marker).

6. Confirm that the LED light located on the grip is lit, signifying that the battery is good

and properly installed.

7. Push the safety switch to the off position toward the rear of the marker.

8. Replace the Grip Panel using the three Grip Panel Screws, being careful not to pinch

the wires leading to the battery connector and those leading to the circuit board.

Attaching Propellant Source

1. Confirm that the Barrel Plug is properly installed and the marker is on "Safe."

2. Cock the marker by pulling the Bolt (#28) in the rearward direction until it "clicks" into

place. This compresses the Main Spring (#2) and allows the Cupseal (#7) to properly seat.

3. Point the marker downward and in a safe direction.

4. Place a few drops of non-corrosive lubricant made specifically for use in paintball (Empire