AWA UCE1168PR Gebrauchsanweisung - Seite 11

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Drehscheibe AWA UCE1168PR herunter. AWA UCE1168PR 17 Seiten. Usb/sd/mp3/cd/radio antique turntable

Seite drucken

GENERAL OPERATION

Notes:

Remove the stylus protector. Be sure that the tone arm is detached from the tone arm rest before

operation and resecured again afterward.

1. Set the "FUNCTION" selector to "PHONO" mode.

2. Set the "SPEED" selector to the proper speed depending on the record to be played.

3. Place the record on the platter.

4. Lift the tone arm from the rest and slowly move it to the record side. The platter will begin to rotate.

5. Place the tone arm on the desired position.

6. Adjust the "VOLUME" control to the desired level.

7. At the end of the record, the platter will automatically stop rotation. Lift the tone arm from the record

and return it to the rest.

8. To stop manually, lift the tone arm from the record, and return it to the rest.

Notes:

As some kind of record the auto - stop area was out of the unit setting, so it will stop before the last

track finish. In the case, set the "AUTO - STOP" selector to "OFF" mode, then it will run to the end of

the record but will not stop automatically. ( Set the "FUNCTION" selector to "OFF" mode or set the

"AUTO - STOP" selector to "ON" mode to stop the playback. ) Put back the tone arm to the rest.

STYLUS REPLACEMENT

Replacement of a worn stylus can be easily accomplished as follows:

1. To remove the old stylus, pull out the stylus

assembly in direction shown, holding the head

shell with your other hand.

2. Then install the new stylus by pushing it gently

into the cartridge ( hold by the edge to prevent

damage to stylus. ) until it clicks into place.

PHONO OPERATION

E-10