EarthQuake E43 earth auger powerhead Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Rasen- und Gartengeräte EarthQuake E43 earth auger powerhead herunter. EarthQuake E43 earth auger powerhead 16 Seiten. Power earth auger
Auch für EarthQuake E43 earth auger powerhead: Benutzerhandbuch (17 seiten)

Seite drucken

EarthQuake E43 earth auger powerhead Benutzerhandbuch

To prevent accidental starting:

Avoid injury! Engine must be turned off and cool,

and spark plug wire must be removed from spark plug

before checking and adjusting engine or equipment.

Avoid injury! Temperature of muffler and nearby

areas may exceed 150° F (65° C). Avoid these areas.

Avoid injury! Check auger often for loose nuts and

bolts. Keep these items tightened.

Auger Maintenance

1. The gear case has 4 oz. of grease installed at the

factory. It is recommended that once a year the gear case

be split and the grease level checked. Add grease only if

level of grease is below top of the gears. A high quality

lithium grease is recommended, which can be purchased at

most automotive and hardware stores.DO NOT OVERFILL.

2. Keep all screws, nuts, and bolts tight.

3. For cold weather operation, store the unit in a cool

environment. Transferring the unit from a warm to a cold

place can cause the build up of harmful condensation.

Engine Maintenance

Avoid injury! Never store engine with fuel in the tank

inside a building. Potential sparks may be present

for ignition of fuel and fuel vapors.

Avoid injury! An adult must always do maintenance

and repair on engine and atachments.

Avoid injury! Engine must be shut-off, cool, and spark

plug wire removed before any repair or maintenance

can be done.

1-800-345-6007

MAINTENANCE AND STORAGE

MAINTENANCE AND ST

CAUTION

ORAGE

Cooling Fins

• Cooling fins, air inlets and linkages must be free from

any debris before each use.

Air Filters

• Never run engine without air cleaner properly installed.

Added wear and engine failure may occur if air cleaner is

not installed on engine.

• Service air cleaner every 3 months or after 20 hours of

operation. Clean and oil filter daily in extremely dusty

conditions.

Steps for Cleaning Air Filters

Never twist air filters when cleaning. Always press.

1. Wash in warm water with mild soap until dirt and debris

are removed. Press filter when washing, do not twist.

2. Rinse in warm water until soap and dirt are removed.

3. Dry filter by wrapping in a clean cloth and pressing filter

until it is dry.

4. Apply oil to the entire filter.

5. Remove excess oil.

6. Attach the filter and filter cover to the engine.

Spark Plug

• Check spark plug every 50 operating hours.

1. Remove dirt and debris around the spark plug before

removing.

2. Remove spark plug and replace if any of the following

have occured: pitted electrodes, burned electrodes,

cracked porcelain, or deposits around the electrodes.

3. Check spark plug for proper gap (.025" to .030").

4. After analysis of the spark plug, install original or a new

spark plug and tighten securely.

NOTE: DO NOT OVERTIGHTEN!

NOTE: CROSS REFERENCE SPARK PLUG IS

CHAMPION CJ8.

Carburetor

• Never tamper with factory setting of the carburetor.

Page 8