EarthWay 0-52732-90399-9 Montageanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Streuwagen EarthWay 0-52732-90399-9 herunter. EarthWay 0-52732-90399-9 8 Seiten. 100lb stainless steel ice melt spreader

Seite drucken

Assembly and Operation Instructions

Step

10: (This step is only required if you want

to change the position of the handles). NOTE:

BEFORE INSTALLING GAUGE AND UPPER

HANDLES TO HANDLE SHAFT, UPPER HANDLES

FEATURE THREE POSITONS FOR OPERATOR'S

COMFORT. If operator chooses middle or upper

positions, use handle spacer in hole nearest to

handle grips.

Insert 2" bolt through upper handle, then

through handle spacer through other upper

handle and secure with locknut. DO NOT

TIGHTEN LOCKNUT YET. TIGHTEN THIS NUT

LAST.

Install HANDLE SHAFT to LOWER HANDLEs and PIVOT & BRACKET assembly as shown. Using 2" bolts and

Step 12:

locknuts. TIGHTEN BOLTS AND NUTS NOW.

Install flattened end of CONTROL ROD

Step 13:

in to LEVER on GAUGE as shown. Turn to lock in

place. Next push LEVER forward to setting "0".

Align CONTROL ROD with hole in PIVOT BRACKET,

pull LEVER backward to insert CONTROL ROD

through hole in PIVOT BRACKET.

Install (1) 1/4‐20 regular nut (not a

Step 14:

locknut) on to CONTROL ROD as shown.

90399_M52162_Oct_2021.docx

Step 11:

Thread hex nut onto the end of the pivot rod.

Insert threaded end of the pivot rod into the shut off

plate.

Thread an additional hex nut on the end of the pivot rod.

Use a 7/16" wrench to secure the hex nut in place around the

shut off plate and pivot rod.

* See Image below. *

PAGE 6