EarthWay 2100P Estate Montage- und Betriebsanleitung - Seite 2
Blättern Sie online oder laden Sie pdf Montage- und Betriebsanleitung für Streuwagen EarthWay 2100P Estate herunter. EarthWay 2100P Estate 8 Seiten. Broadcast spreader
Auch für EarthWay 2100P Estate: Montage- und Betriebsanleitung (6 seiten)
Seite drucken
Impeller
Gearbox Assembly
3. Install impeller onto pinion shaft. Insert ⅛"x 1¼" Cotter pin
through impeller then through pinion shaft. Use hole closest to the
gear box. Spread cotter pin to prevent from falling out.
Axle Bearing
Flat
Side
5. Install axle bearings to both Draw bars.
NOTE: Notch on bearings and in the Draw
bar line up. Bearings must go through flat
side of lower handle.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST
PAGE 2
Pinion
Shaft
⅛ x 1¼"
Cotter Pin
Notch
COAST WHEEL SIDE
¼-20 x 1¼"
Hex Head Bolt
¼-20 x 2"
Hex Head Bolt
6. Install lower handles onto axle to both sides as shown. Insert ¼-20 x 2" bolt through hole
in Draw Bar and through first hole in frame install locknut. DO NOT TIGHTEN. Next insert
¼-20 x 1¼" bolt through frame brace and through second hole in frame install locknut.
STEP. DO NOT OVER TIGHTEN.
SLIDE
4. Install gear box by inserting the pinion shaft into hole in center of hoppers
bottom. The word "FRONT" on the gearbox must point to F
hopper. Follow label instructions on hopper. Next, slide axle thru the gearbox
with the drive wheel hole positioned as shown in the drawings below.
Gearbox Assembly
Impeller
¼-20 Locknut
Gearbox
FRONT
ront
DRIVE WHEEL SIDE
Frame brace
Draw Bar
Shut-Off
of the
Frame
Flat Head
Screw