EarthWay 2170 Montage- und Betriebsanleitung
Blättern Sie online oder laden Sie pdf Montage- und Betriebsanleitung für Streuwagen EarthWay 2170 herunter. EarthWay 2170 8 Seiten. Commercial broadcast spreader with side spread control
Auch für EarthWay 2170: Montage- und Betriebsanleitung (6 seiten), Betriebsanleitung (8 seiten), Montageanleitung Handbuch (12 seiten), Montage- und Betriebsanleitung (6 seiten), Montageanleitung Handbuch (10 seiten)
Seite drucken
2170 C
ommerCial
B
roadcast
ASSEMBLY and OPERATING INSTRUCTIONS
PLEASE CONTACT US IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY
QUESTIONS REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME
TECHNICAL SUPPORT. HOT LINE: 574-848-7491 OR 800-294-0671, EMAIL: [email protected]
HELPFUL HINTS:
; If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader.
The impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise.
Clean the impeller plate after each use. Fertilizer stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or
faster speeds will change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate.
Clean and dry your spreader thoroughly after each use. Coat all metal surfaces (inside & outside of tubing)
with light oil or silicon spray to help prevent corrosion. Wash between the shut off plate and bottom of the
hopper. Do not use powdered materials.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #7
32100
33117
Qty 2
Qty 1
36210
Qty 2
36214
31100
Qty 4
Qty 4
12152
12148
Qty 2
Qty 2
1. Remove and identify all loose parts from carton
(Qty 4 #36214)
1/4-20 X 1½"
Phillips Panhead
s
preader
READ THE DIRECTIONS BEFORE ASSEMBLY
36300
32103
Qty 6
Qty 9
33108
36105
Qty 1
Qty 1
33109
Qty 1
31120
Qty 5
31106
Qty 2
.
(Qty 4 #36300)
1/4-20 SS Locknut
ROCK SALT and POWDERED MATERIALS
should not be used in this spreader as
it will damage gearbox and can void
Use only granular materials.
13
16
31
2. Position hopper on side. Install frame using (4) 1/4-20 x 1-1/2"
Pan Head Phillips bolts and (4) 1/4-20 nylon insert locknuts. First put
bolts through holes in frame then through holes in bottom of hopper.
Secure with locknuts. TIGHTEN THESE LOCKNUTS NOW - DO NOT
TIGHTEN WITH POWER TOOLS. TIP: coat stainless steel bolts
with wax or grease before tightening to prevent them from seizing.
warranty.
24
23
17
9
40
25
26
38
8-2014 Pt# 52164
12
11
28
PAGE 1