Earthwise Electronics ComfortZone Benutzerhandbuch - Seite 14
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Heizungsanlage Earthwise Electronics ComfortZone herunter. Earthwise Electronics ComfortZone 14 Seiten. Therapeutic infrared heating systems
Seite drucken
Page 13
Detailed Operating Instructions
Turning Power On
1. Press the POWER button on the left side of the Control Panel. The heater's
quartz heating elements will light up inside the heater.
2. After a few minutes, once the air within the heater is warm, the heater fan
(some models have 2) will begin to operate.
Turning Power Off
1. Press the POWER button located on the left side of the Control Panel.
2. The sound of the heater fan will continue until the heat has been
completely vented, thus protecting the unit and preventing waste by
cycling the remaining heat into the room. (NOTE: DO NOT unplug the heater
until the sound of the fan has stopped. Doing so may cause damage to the
unit.)
Setting the Temperature
This feature allows you to set the temperature your heater will maintain.
1. Press the temperature (TEMP) button on the Control Panel; the SET TEMP
indicator will illuminate and the temperature display will flash.
2. Use the UP and DOWN buttons to select the temperature and press enter.
3. The SET TEMP light will turn off, and the temperature is now set.
Customer/Warranty Service: (866) 446-2864
Detailed Operating Instructions
Setting the Timer
This feature allows you to set a future time for the heater to turn itself on. For
example, if you set the time for 1 hour, the heater will turn on in 1 hour.
1. Turn the power off (heater must be powered off to use the timer feature).
2. Press the TIME button on the Control Panel—the two zeros to the right will
flash (:00), indicating 0 minutes have been set, and the DELAY START
indicator will illuminate.
3. Press the UP or DOWN button to select desired number of minutes (up to 59
minutes) that you would like the heater to wait to turn itself on.
4. P ress the ENTER button—the two zero buttons to the left will flash (00:),
indicating 0 hours have been set.
5. Press the UP or DOWN button to the desired number of hours (up to 24
hours), and then press the ENTER button.
6. D ELAY START indicator will flash until the unit comes on after waiting the
period of time you have set.
7. To cancel the timer, press the power button and the timer will stop.
Switching Between Fahrenheit & Celsius
Press the DOWN & ENTER buttons simultaneously and hold for about 3
seconds. The display will update automatically.
Page 14
©2008 EarthWise Electronics, Inc