Alligator P-25 Gebrauchsanweisung - Seite 2

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Transmitter Alligator P-25 herunter. Alligator P-25 2 Seiten. Digital fm transmitter with auto power adaptor

Seite drucken
Specification
1.
Input Voltage:
2.
Output Voltage:
3.
Safety fuse:
4.
High-stability crystal oscillator
5.
Phase-lock loop control
6.
Radio Frequency Range:
7.
Frequency Response: 150Hz to 20KHz
8.
Stereo separation:-25dB at 25cm
9.
Signal distortion: less than 5%
10. Station Memory Presets:
11. Maximum receivable range:
Precautions
l
When iPod is in use with FM transmitter with Car Adaptor, avoid using it with any devices simultaneously.
"NOTE:Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment."
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
FCC ID: S4CKC9512
MADE IN CHINA
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
Date:25/11/2005
DC12 V
0.8A
DC11.3 V
0.8A
1A
88.1MHz-107.9MHz
10 Channels
19.5 feet