Christie 103-009100-01 Anleitungsblatt
Blättern Sie online oder laden Sie pdf Anleitungsblatt für Projektor-Zubehör Christie 103-009100-01 herunter. Christie 103-009100-01 4 Seiten. Lamp/filter replacement
Seite drucken
LX380-LX450 Lamp/Filter Replacement
These instructions outline the details for Lamp and Filter replacement in the LX380/380L projector (Model
No. 103-009100-01/103-017101-01) and LX450 projector (Model No. 103-010100-01). The lamp is located
on the right side of the projector (viewed from the back) and the filter is located on the left side of the projector
(viewed from the back). NOTICE: Use only a Christie approved Lamp and Filter Kit for your specific
projector model.
KITS REQUIRED
• Lamp - p/n 003-120242-01
• Filter - p/n 003-001109-01
TOOLS REQUIRED
Phillips screwdriver
INSTRUCTIONS
LAMP REPLACEMENT
bang, or burn out, if jolted or scratched or handled while hot, or wear out over time. If the lamp should
explode, immediately disconnect all power sources to the projector. Ventilate the room well, and make sure
not to breathe the gas that comes out of the projector vents. Avoid contact with eyes and mouth.
hazard, or other accidents.
sufficiently. Handling the lamp while hot can cause burns, as well as damaging the lamp. Shards of glass
may damage internal projector components or cause injury during handling.
LX380/LX450 Lamp/Filter Replacement Instruction Sheet
020-000107-01 Rev. 1 (10/08)
The projector uses a high-pressure mercury glass lamp which can explode with a loud
Do not use an old (used) lamp as this may cause it to explode.
Do Not operate a projector while any lamp is removed. This may result in malfunctions, fire
When replacing a lamp that has burnt out, wait at least 45 minutes for the lamp to cool
Never unscrew except the appointed (marked by an arrow) screws.
Instruction Sheet
1 of 4