Christie Terra TXO 102 SO Handbuch für Einrichtung und Installation - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Einrichtung und Installation für Controller Christie Terra TXO 102 SO herunter. Christie Terra TXO 102 SO 17 Seiten. Controlled systems

Seite drucken

Accessories

10G Network switch

One 1G Ethernet cables (CAT-6)

If the network switch does not offer RJ45

connections for 1G Ethernet communications, use

two 1G SFP transceivers compatible with the SFP+

adapters on the network switch, or connect to the

Terra 1G LAN ports.

HDMI out cable for each RX

AV source devices

Audio cable: 3.5 mm stereo mini-jack

Remote control cables: IR transmitter 3.5 mm DC mini-

jack cable; IR receiver 3.5 mm stereo mini-jack cable

Terra Controller Ports and Status Indicators

Power indicator

LED display for IP address and startup status

Power switch

DisplayPort 1.2 output port (female), unused

Serial RS-232 port for connecting to 3

1000BASE-T Ethernet connector for device control and optional access for 3

Unused

USB connectors V2.0, unused

C10

15PinHD output port,, unused

C11

DisplayPort 1.2 output port (female), unused

C12

Power supply port (low voltage)

Terra TX and RX Connections

Refer to

TX and RX Ports and Status

AV Processing System Setup

For proper ventilation and to prevent damage to the unit, ensure the wiring or other material does not obstruct the

air flow to or from the air vents.

Prepare a networking plan including the IP address range, subnet mask, and gateway values for the

controller and associated Terra devices.

For ease of identifying all the hardware, attach the extra MAC address sticker (found in the accessory bag)

to the front or rear of each TX and RX.

Power off all equipment and install in a rack or set on a table.

Power on the 10G network switch.

Prepare the network for Terra multicast by configuring the switch for IGMP V2 Multicast management

including IGMP Snooping and Querier, Immediate leave, and Drop unregistered multicast on the SDVoE

VLAN.

Use Wireshark or Netmon applications on a laptop or PC connected to the Terra 10G network to validate the

presence of these protocols while operating the Terra system.

Terra Controller Installation and Setup Manual

020-102804-02 Rev. 1 (09-2018)

Required

PC or other Window-based device with a web browser

For each TX and RX, one 10G Ethernet Twinax cable (.5 to

7m); or SFP+ 10G transceivers compatible with the

network switch and OM3 multimode 850nm fiber cable with

duplex LC-LC connectors (300m maximum distance)

Single mode fiber or Category cable such as CAT-6a can

be used with Terra TXs and RXs by substituting

compatible 10G SFP+ transceivers and compatible

cables.

10G SFP+ Direct Attach Cables or Twinax copper cables

with hard wired SFP+ transceivers can also be used.

HDMI IN cable or DisplayPort cable for each TX

AV display devices (embedded audio ready for HDMI audio)

Optional

USB cables

Serial RS-232 cable 9PinD male and female

connectors

Party control system

Indicators, page 6.

Install and Setup

Party control system