Miele PG 8581 Ergänzendes Dokument - Seite 18

Blättern Sie online oder laden Sie pdf Ergänzendes Dokument für Waschmaschine Miele PG 8581 herunter. Miele PG 8581 40 Seiten. Washer disinfector

Seite drucken

Problem Solving Guide

WARNING!

PERSONAL INJURY AND EQUIPMENT

DAMAGE HAZARD

Repairs may only be carried out by Eschmann.

Repairs and other work by unqualified persons

could be dangerous for the user.

The following guide may help you find the reason for a fault

and correct it.

To avoid unnecessary service call-outs, check that the fault

has not been caused by incorrect operation when an error

message first appears.

6.1. Messages

Problem

The display is dark and all

the LEDs are out

The machine has switched

itself off

Next service due on

6.2. Dispensing/ Dispensing Systems

Problem

DOS refill

DOS Vent at the end of the

programme

Programme could not be

started. Vent DOS

Cause and remedy

The machine is not switched on.

Switch the machine on using the

A fuse is defective or has tripped

Minimum fuse rating – see data plate

Reset the trip switch

If the mains fuse trips again, call Eschmann.

This is not a fault

If activated, the Auto-Off function switches the machine off automatically after a pre-set

duration to save energy.

Switch the machine on using the

This is not a fault

Eschmann has recommended a date for the next service visit.

Please contact Eschmann to arrange a service visit.

Cause and remedy

During a programme sequence a low level of liquid chemicals in a container has been

identified.

Exchange it for a full container before the start of the next programme.

During a programme sequence a low level of chemicals has been identified.

There may be air in the dispensing system.

Allow the programme to continue to the end.

Vent the dispensing system at the end of the programme.

A programme cannot be started because...

• there is air in the dispensing system

• the dispensing system has been sucked completely dry.

Check level in the supply container and refill or replace it with a full container as necessary.

Vent the dispensing system.

For all fault messages:

If the cause is not remedied and the machine is switched off,

when it is switched back on again the fault message must be

acknowledged with the code. The machine will be locked for

further use until this is done

button.

MUW216743-2