Miele PW 6101 Betriebsanleitung - Seite 25
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Waschmaschine Miele PW 6101 herunter. Miele PW 6101 44 Seiten. Profitronic m innovation m
Auch für Miele PW 6101: Betriebsanleitung (46 seiten), Programmieranleitung Handbuch (48 seiten), Programmieranleitung Handbuch (48 seiten)
Seite drucken
Priming the dispensing pumps
Use the calibration to get liquid detergent to
the pumphead. Once calibration is complete
run an empty program to get detergent to
the machine before actually washing a load
of laundry in the machine.
Dispensing calibration
The dispensing calibration is used to
calculate the flow rate of each single
dispensing pump.
Direct access to the dispensing calibration
when the machine is turned off:
^ Press and hold the 2
^ Turn the machine on at the mains.
Dispensing calibration ~ Main menu
Dispensing pump 1
Dispensing pump 2
Selections: Dispensing pump 1 to 13
After selecting a dispensing pump the
display shows:
Dispensing calibration ~ Dispensing pump 1
V: 100ml
t: 0s
The dispensing amount can be adjusted in
1 ml increments from 0 to 999 ml.
^ Press the control key 0/1, the dispensing
hose fills. Press the 0/1 button again to
stop.
^ Hold the hose, of the dispensing pump to
be determined, in a measuring cup.
,
Avoid skin and eye contact, wear
protective clothing.
^ Press A to get back to the main menu.
nd
control key.
e
A
P: 200.0 ml/min
0/1
A
S
Optional modules
Dispensing calibration
Dispensing pump 1
Dispensing pump 2
^ Select the dispensing pump.
Dispensing calibration
V: 100ml
t: 0s
^ The dispensing can be manually stopped
by pressing the 0/1 button or it will stop
automatically after 60 seconds.
^ Measure the pumped amount in the
measuring cup.
Dispensing calibration
V: 100ml
t: 30s
^ Enter the measured amount in the "V:" field.
The flow rate P is calculated by the control.
^ Press S "Save" to allocate the measured
values to the dispensing pump.
^ Reconnect the hose.
Maintenance of the dispensing system
^ Rinse the dispensing system with hot
water every 2 weeks, or before shutting
down the dispenser pumps for any length
of time, to prevent the system from
clogging.
^ Rinse out the suction pipes with water.
^ Place the suction pipes in a container with
warm water, 104 - 122°F (40 - 50°C).
^ Select each pump by using the dispensing
calibration.
^ Turn on each pump until the dispensing
system is rinsed.
^ Check the connection points, hoses and
washers for leaks.
Main menu
e
A
Dispensing pump 1
no
A
S
0/1
Dispensing pump 1
P: 200.0 ml/min
A
S
0/1
25