Miele PW 6241 Betriebs- und Installationsanleitung - Seite 37
Blättern Sie online oder laden Sie pdf Betriebs- und Installationsanleitung für Waschmaschine Miele PW 6241 herunter. Miele PW 6241 44 Seiten.
Auch für Miele PW 6241: Betriebs- und Installationsanleitung (44 seiten), Betriebsanleitung (46 seiten), Programmieranleitung Handbuch (48 seiten)
The washer must only be installed by a Miele
authorized service technician.
Before installation or service disconnect the power
supply to the work area.
The minimum dimensions and distance required
from the wall, as shown in the installation diagram,
must be observed to allow service to be
performed and the data plate to be viewed.
Installation site
A concrete or reinforced floor is the most suitable
surface for the washer. These types of floors are less
prone to vibration during the spin cycle.
The washer must be leveled for proper operation. The
machine does not need to be installed on a base,
however, any unevenness in the floor must be
compensated for.
Do not install or store this machine in a room
where temperatures below freezing may occur or
where the machine may be exposed to the
weather.
Do not install the washer on carpeting. Carpeting
will block the washers air vents.
Installation Instructions
Removing the shipping struts
^ The fixing angles "A" on the diagram, 2 on each
side panel are fixed with 3 M 10 (SW 17) hex
screws. Remove these.
The shipping struts "B" on the diagram, 2 at the front
and 2 at the rear are each fixed with 3 M 10 (SW 17)
hex screws.
^ To remove them detach the front service panel and
the rear panel. Unscrew the 3 M6 hex screws (SW
8) at the bottom edge of the front service panel,
and take it off.
Unscrew 8 hex screws in the rear panel and remo-
ve.
The cover for the bottom front and the rear panels are
secured to the side panels, and should be fitted when
the machine has been installed. Use the supplied
screws.
The shipping struts should be stored in a safe
place for future use. They must be refitted if the
machine is moved.
37