Miele W 6071 Betriebsanleitung - Seite 24
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Waschmaschine Miele W 6071 herunter. Miele W 6071 38 Seiten.
Auch für Miele W 6071: Betriebsanleitung (40 seiten), Betriebs- und Installationsanleitung (44 seiten)
Seite drucken
Liquid dispensing
Commissioning the dispensing
pumps
Before the liquid dispensing pumps can be
used the liquid detergent must be drawn into
the system and the amount to be dispensed
set. The Service Programme is used for this.
Drawing in the liquid detergent
^ Insert the suction pipes into the liquid de-
tergent containers.
Service operation:
^ Switch off the washer extractor.
^ Operating mode B, set the programme se-
lector switch to 24.
^ Switch on the washer-extractor, and within
4 seconds, press the Block plus button T
4 times in quick succession. This brings
you into Service operation. The cursor is
already at the Service programmes.
SERVICE - OPERATION
>SERVICE PROGRAMMES< MACHINE DATA
After selection press Start button.
^ Press the Start button X .
SERVICE - OPERATION
SERVICE PROGRAMME
After selection press Start button. ->
^ Select SERVICE PROGRAMME 2 with the
Plus button 4 and press the Start button X.
SERVICE - OPERATION
SERVICE PROGRAMME
Dispenser valve >D1<
After selection press Start button.
^ With the Plus button 4 select D1, with the
Cursor button 2 move to the input field for
dispensing time and with the Plus button
4 set a dispensing time of approx. 20
seconds. Press the Start button X, and the
hoses of pump 1 will be filled.
24
->
SERVICE PROGS
>1<
SERVICE PROGS
2
Disp. time 0 Secs
SERVICE - OPERATION
SERVICE PROGRAMME
Dispenser valve >D1<
Cancel with the End button.
^ Cancel with the End button 7.
Repeat the whole process with other pumps
(D2 and D3).
SERVICE - OPERATION
>SERVICE PROGRAMMES<
After selection press Start button.
^ Press the Start button, select the SERVICE
PROGRAMME 2, and press the Start but-
ton X .
To exit from Service operation:
^ Cancel with the End button 7 and switch
off the machine.
^ Switch the machine on and select
Programme 8 , SEPARATE RINSE and
SPIN, to flush the proofing agent out of the
machine.
To correct the amount dispensed by the
pumps (should the dispensing times set not
be enough)
The amount to be dispensed is measured
out in litres in the Service programme. The
procedure is similar to the one for drawing
up the liquid detergent. The dispensing time
decided on is then set in the operating mode
C Programming in the step programming.
The maximum pump throughput is
approx.168 ml/min. for all pumps.
These figures are only intended as a guide,
and will vary according to the medium.
^ Put the suction pipe into a deep measuring
container with sufficient liquid detergent
and keep it at the full level.
Continue as for Drawing in liquid detergent
SERVICE PROGS
2
Disp. time 20 Secs.
MACHINE DATA
->
M.-Nr. 06 006 850