Allmatic ACTION Anweisungen für die Installation

Blättern Sie online oder laden Sie pdf Anweisungen für die Installation für Kontrolleinheit Allmatic ACTION herunter. Allmatic ACTION 5 Seiten. For tecno-cat

Seite drucken

1. Introduction

Action is a control unit dedicated to the movement of the chain barrier with 24Vdc motor. The coexistance of various types of safeties such as the con-

trol of the absorbed power by the motor and the velocity of the motor allows a rapid intervention of the anti – squeezing security (sense). Through the

encoder present in the motor it is possible to control the exact position of the chain and to use it without mechanical limit switches. The control unit has

inputs for mechanical limit switches, for the step by step button, for the pedestrian opening, for the safety photocells and the output for flashing light 24

Vac. The unit also allows the regulation by trimmer both the automatic re-closure and the motor force. Action can control motors at 24 – 30 Vcc with a

maximum consumption of 7A.

2. Configuration

Use this point to connect

the motor's casing to the

control panel and to the

ground.

Jumper ( if present)

in order to invert the

motor phases

Connector for the

battery charger.

24Vac Power supply

3. Electrical connections

Terminal

Function

1 – 2

Flashing signal output

Positive power supply TX & RX photocell

Negative power supply TX photocell

Negative power supply RX photocell and

common button and safety

Stop closure button input

Stop open button input

STOP button input

RX photocell contact input

Pedestrian button input

Relay button input

Antenna screen input

Antenna input

IMPORTANT: to obtain a correct working of the accessories (photo devices in particular) connected to the control box, it is very important that the

entire system (motor+ control box) has a single mass reference system. You must therefore connect a small cable between the motor casing and the

control box at the point shown in the figure. If there is a good ground connection it is advisable to connect it to the system.

6-1622349 rev.3 28/03/2019

ACTION CONTROL UNIT for Tecno-cat

INSTRUCTIONS FOR INSTALLATION

Automatic

re-closure

Courtesy light

Motor/ Encoder Connector

Setting

OUT: 24 Vac 25 W MAX

OUT: +24Vcc

OUT: GND TX

OUT: GND RX

Common

Normally closed (NC)

Normally open (NO)

GND

Antenna

Any contact which is

Normally Closed (N.C.)

Must be bridged to the

common if not used.

ITA

ENG

Photocells

Power supply

9 10

Note: Cable colours valid only for Tecno-cat motor.

FRA

ESP

DEU

POR

Setting maximum

torque threshold.

Radio connector

Buttons:

1 = yellow

2 = Blue

3 = Red

Manual selector (Left) /

automatic (Right).

Motor/ Encoder Connector.

Encoder +5Vcc (brown)

Signal (green)

GND (white)

Motor

pag. 1 di 5