Miele DA 199 Betriebsanleitung - Seite 15
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Lüftungshaube Miele DA 199 herunter. Miele DA 199 28 Seiten. Cooker
Seite druckenElectrical connection and Technical data
Electrical connection
General notes
All electrical work should only be under-
taken by a suitably competent person
in strict accordance with national and
local safety regulations.
For extra safety it is advisable to install
a residual current device (RCD) with a
trip current of 30 mA.
The Technical data table (next page)
gives details for each appliance.
The data plate gives the necessary
data for connection. This is visible
when the grease filter has been
removed.
Check that these data correspond with
the voltage and frequency of the on-
site electricity supply.
Only for U.K.: Connection should be
made either by a double pole fused
spur connection unit or a fused plug
and switched socket. The On-Off
switch should be easily accessible
after the appliance has been built in.
Electrical connection U.K., AUS, NZ
The cooker hood is supplied for con-
nection to an a.c. single phase 230 -
240 V, 50 Hz supply.
Electrical connection and Technical data
Important
The wires in the mains lead are col-
oured in accordance with the following
code:
Green/yellow
Blue
= neutral
Brown
= live.
If the appliance is to be connected via
a plug and socket, please note the fol-
lowing:
As the colours of the wires in the mains
lead of this appliance may not corre-
spond with the coloured markings ident-
ifying the terminals in your plug, pro-
ceed as follows:
The wire which is coloured green and
yellow must be connected to the termi-
nal in the plug which is marked with the
letter E or by the earth symbol z or col-
oured green or green and yellow.
The wire which is coloured blue must
be connected to the terminal which is
marked with the letter N or coloured
black.
For U.K.: The wire which is coloured
brown must be connected to the termi-
nal which is marked with the letter L or
coloured red.
For Australia / New Zealand: The wire
which is coloured brown must be con-
nected to the terminal which is marked
with the letter A or coloured red.
WARNING:
THIS APPLIANCE MUST BE
EARTHED
= earth
15