Miele DA 216-2 Betriebs- und Installationsanleitung - Seite 17

Blättern Sie online oder laden Sie pdf Betriebs- und Installationsanleitung für Lüftungshaube Miele DA 216-2 herunter. Miele DA 216-2 40 Seiten. Miele operating and installation instructions cooker hoods da 216-2, da 216-2 ext, da 217-2, da 219-2, da 219-2 ext

Seite drucken

Re-usable metal filters are fitted which

remove solid particles (oil, dust, etc.)

from the kitchen vapours, preventing

soiling of the cooker hood.

The filters should be cleaned regularly

(at least every 3-4 weeks) to avoid a

build-up of fat, but always clean as

soon as the grease filter touch control

lamp comes on.

An over saturated filter is a fire

hazard.

To take out the grease filters press

the locking clips in towards the

middle of the filter. Holding carefully,

lower and remove the filter.

Clean the filters

–

with a nylon brush warm

water with a little washing up liquid.

–

with the short side upright in the

place the filters

lower basket, ensuring the spray arm

is not obstructed.

Depending on the cleaning agent

used, cleaning the grease filters in

a dishwasher can cause permanent

discolouration to the surface of the

filters.

However, this will not affect the func-

tioning of the grease filters in any

way.

After cleaning, leave the filters to dry

on an absorbent surface before put-

ting them back in place.

When removing the filters for clean-

ing also clean off any residues of oil

or fat from the now accessible hous-

ing to prevent the risk of these catch-

ing fire.

When replacing the grease filters, en-

sure the locking clips are visible facing

down towards the hob.

Should the grease filters be put back

upside down:

insert a small screwdriver into the slits

to disengage them. Do not let them

drop on to the hob below.

After replacing the grease filters,

press the grease filter touch control

for approx. 3 seconds to re-set the

operating hours counter. The indica-

tor lamp will go out.

If the grease filters are cleaned be-

fore the operating hours counter has

reached its maximum, the grease fil-

ter touch control should be pressed

for approx. 6 seconds to reset the

counter to zero.