Warning:
For safety reasons, only connect
equipment with a telecommunications compliance
label. This includes customer equipment previously
labeled, permitted or certified.
The grant of a Permit/Telepermit in no way indicates
the telecom agency's acceptance of responsibility for
the correct operation of that device under all operating
conditions. In particular, the higher speeds at which
this modem is capable of operating depend on a
specific network implementation which is only one of
many ways of delivering high-quality voice telephone to
customers. Failure to operate should not be reported
as a fault to Telecom or Austel.
In addition to satisfactory line conditions, a modem
can work properly only if:
It is compatible with the modem at the other end of
n
the call, and
The application using the modem is compatible with
n
the application at the other end of the call; for
example, accessing the Internet requires suitable
software in addition to a modem.
This equipment shall not be used in any manner which
could constitute a nuisance to other customers.
The setting and features discussed below influence
how your modem reacts with the telephone network. If
changes from the default values are made, then it is
possible that unwanted signals or interference may be
generated, your modem might dial wrong numbers or
suffer from a reduced level of performance. We
strongly recommend that the settings are not changed
under any circumstances or the Permit/Telepermit
may become invalid.
Initialization
Many communications programs react to the default
settings when started. This is usually achieved by the
ATZ command and initializes your modem for correct
operation. Many programs are developed for worldwide
use and generally use the ATZ command; however,
some programs have built-in modem configuration
utilities and these should not be used unless you can
confirm that they are compatible with Australian and
New Zealand requirements.
If your program does not use the ATZ command to
initialize, but instead sends a complex string of
characters, then it must be configured to send the
correct string for Australia and New Zealand. The
correct initialization string is (spaces should not
be entered; they are to make it easier to read):
AT &F T /N6 S6=3 S7=45 % L=7 &Y0 &W0
Seite drucken