Burk Plus-X 300 Installations- und Betriebshandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Transmitter Burk Plus-X 300 herunter. Burk Plus-X 300 9 Seiten.

1-8 numbering on the chassis. Insert a common ground reference to the Phoenix connector to

align with the ground symbol on the chassis. Tighten the set screws.

Relay Output Wiring

Command output wiring is facilitated by the two 12-pin connector blocks. Each relay 1-8 has

Common (C), Normally Open (NO) and Normally Closed (NC) connections labeled on the rear

panel. Loosen the set screws on the Phoenix connectors and make wiring connections

according to the requirements of the site equipment under control. Tighten the set screws.

When finished making equipment connections, disconnect the Phoenix connectors from the

Plus-X 300 until configuration is complete.

Power & Ethernet Connections

Apply power to the Plus-X 300 by connecting the 2-pin power connector to the rear-panel input

marked POWER. The power connector is pre-wired to the 15V wall adapter. Plug the power

adapter into a standard 120V outlet. The POWER LED will illuminate.

Finally, connect the included Ethernet cable to your network switch.

Important!

The Plus-X 300 must be addressable by the ARC Plus to which it will communicate. Consult your IT

department prior to configuration to resolve any IP address or firewall conflicts.

Configuration

Configuring the Plus-X 300 involves establishing the network settings, setting up channel

parameters, setting the password, and then adding the newly configured Plus-X channels to the

ARC Plus system.

To configure the Plus-X 300, open a web browser and enter the unit's IP address in the address

bar. Prior to network configuration, the Plus-X 300 operates on a default IP address of

192.168.0.100. When the login screen appears, enter the user name and password for the unit.

The user name is admin and the default password is password.

Plus-X 300 Installation and Operation Manual Rev C