IMPORTANT SAFETY INSTRUCTIONS
Technical safety
~
Installation, repair and maintenance
work should be performed by a Miele
authorized service technician. Work by
unqualified persons could be
dangerous and may void the warranty.
~
Be sure your appliance is properly
installed and grounded by a qualified
technician.
~
Before installing the combiset,
check for externally visible damage.
Do not operate a damaged appliance.
~
To guarantee the electrical safety of
this appliance, continuity must exist
between the appliance and an effective
grounding system. It is imperative that
this basic safety requirement be met. If
there is any doubt, have the electrical
system of the house checked by a
qualified electrician. The manufacturer
will not be held responsible for
damages caused by the lack, or
inadequacy, of an effective grounding
system.
~
Before installation, make sure that
the voltage and frequency listed on the
rating label correspond with the
household electrical supply. This data
must correspond to prevent injury and
appliance damage. Consult a qualified
electrician if in doubt.
4
~
Do not use an extension cord to
connect this appliance to electricity.
Extension cords do not guarantee the
required safety of the appliance.
~
Install the appliance so that the
power cord does not come into contact
with any portion of the combiset which
may become hot during use.
~
Before servicing, disconnect the
appliance from the main power supply.
~
Do not operate any appliance with a
damaged cord or plug, or if the
appliance has been damaged in any
manner. Contact Miele's Technical
Service Department.
~
Under no circumstances open the
outer casing of the appliance.
~
While the appliance is under
warranty repairs should only be
performed by an authorized service
technician. Otherwise the warranty is
void.
~
In the event of any damage to the
appliance, it must be turned off
immediately and disconnected from the
main power supply. Contact Miele's
Technical Service Department.
Do not use the appliance until it has
been repaired. Ensure power is not
supplied to the appliance until repair
work is completed.
Seite drucken