ALLNIC AUDIO A-2000 MK3 Benutzerhandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken ALLNIC AUDIO A-2000 MK3 herunter. ALLNIC AUDIO A-2000 MK3 14 Seiten. Kt170 push-pull stereo power amplifier
Seite drucken• "On-the-Fly" Triode/Pentode Switching. Switching between triode and pentode operation can be done "on-the-
fly" at any time while the amplifier is in use.
• Beautiful 20KHz square wave response. See Figures 1-3.
Fig.1 Square Wave 50Hz*
• As are all Allnic Audio products, the A-2000 MK3 is fully RoHS (EU Reduction of Hazardous Substances
regulation) compliant in construction and materials.
WHAT'S IN THE BOX?
Please check that the pair (assuming you purchased a pair) of shipping boxes contains the following:
•
One (1) each Allnic A-2000 MK3 Stereo Power Amplifier
•
One (1) each 15 amp IEC type power cord
•
One (1) Owner's Manual
Note:
1)
The A-2000 MK3 ships with the tubes installed.
2)
The A-2000 MK3 will work with most IEC type aftermarket power cords. The Allnic ZL-3000, ZL-5000
and ZL-8000 power cables will make an excellent match. Of course, only you can determine the power
cord that works most synergistically with the A-2000 MK3 in your system.
3)
Be sure the A-2000 MK3 is labeled for the AC voltage of your location. If it is not, DO NOT connect it
to your AC outlet. Please contact your Allnic dealer.
We advise that you keep the boxes and other packing materials that your A-2000 MK3 came in. It will be useful
if you sell your A-2000 MK3 or in the unlikely event you need to ship it for service.
SAFETY
•
Remove ALL protective cushioning material (cardboard/styrofoam around the tubes) inside the tube
chimneys before operation. The tube chimneys should contain NOTHING except the tubes
optional to leave the "O" rings, if any, on the small tubes; some prefer the sound with the O rings
on).
•
Disconnect the power cord by pulling the plug, not the cable.
•
Do not attempt any repairs. Do not remove the unit's chassis cover without specific authorization from
your Allnic dealer.
•
Keep the power cord away from heat sources
•
Keep the unit away from liquids – do not allow any liquid to enter the interior of the unit.
*
Measured by LEADER LAG-126 Audio Signal Generator and KENWOOD CS-4125 Oscilloscope.
Fig.2 Square Wave 1KHz*
5
Fig.3 Square Wave 20KHz*
(It is