ALLNIC AUDIO D-10000 Benutzerhandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Medienkonverter ALLNIC AUDIO D-10000 herunter. ALLNIC AUDIO D-10000 16 Seiten. Digital to analog converter

Seite drucken

Pressing the lower part of the black main button ring selects the various inputs from left to

•

right on the face of the unit

Pressing the right side of the black main button ring toggles CONV, conversion to DSD, on and

•

off, i.e., between conversion to DSD and a source's incoming sample rate, or one of the up-

sampling rates (the latter only if you were previously in up-sampling)

Pressing the silver central "enter" button toggles UPSAMPLE on and off and when on, cycles

•

through the various up-sampling rates

The remote control's "left" side of the black main button ring, the "Menu" and the "Play/Pause"

buttons have no functions for the D-10000 OTL/OCL DAC.

If you are using an Apple device as a source or controller, or have any other Apple device nearby, it

may also respond to the D-10000 remote control. If you need to use an Apple device at the same time

as you are using the D-10000 OTL/OCL and cannot move your Apple device out of range of the D-

10000 remote control, you should be able to disable the remote control sensor of the Apple device in

the device's System Preferences. Instructions for doing this are available on-line.

THE BALANCE METERS

The illuminated meters on the D-10000 OTL/OCL's front panel indicate the DC balance status of the

6C19P output tubes for each channel. The needle of each meter should be at the center of the meter.

If one needle is, or both needles are, off-centered, please adjust the potentiometers located on the

top panel between two of the 6C19P output tubes. If a meter will not balance, please contact your

Allnic dealer for assistance.

TUBES

There is a set of four (4) tubes for each channel, with the right and left channels each arranged in a

row from front to rear. The D-10000 OTL/OCL uses the following tubes:

•

Two (2) x 7258 (the tubes closest to the front of the DAC)

Two (2) x 12AU7 (the tubes second from the front, i.e., between the 7258 and 6C19P tubes)

•

Four (4) x 6C19P (the four tubes closest to the rear of the DAC)

•

All consequences of changing or attempting to change tubes are borne by the user unless by express

agreement between the owner and the Allnic dealer. The Allnic dealer, Allnic Audio and Audiomentors

are not liable in any way whatsoever for any injury or loss incurred by the user or for damage to the

D-10000 OTL/OCL, any of its parts, or tubes or replacement tubes resulting from the user changing or

attempting to change tubes.