Alloy POE120 Series Produkthandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Produkthandbuch für Medienkonverter Alloy POE120 Series herunter. Alloy POE120 Series 9 Seiten. 10/100 base-tx to 100base-fx converter poe powered device

Seite drucken

9. DIP Switch Configuration

Fig. 11 Reset button and S1 – Bit 1, 2, 3, 4, 5, 6, Configuration and Settings

Reset

S1-1 TP Port Mode

S1-2 TP Port Speed

S1-3 TP Port Duplex

S1-4 LFP

S1-5 Fibre Port Duplex

S1-6 POE ON/OFF

Note:

1. S1-2 and S1-3 will take effect only when S1-1 is set to TP-Force

2. S1-5 must be set to 100FDX for Single Fibre Model

3. S1-6 must be set to POE when you need to supply power to a PD.

Warning:

When a Copper port set to AUTO and is connected to a device that is

Forced to 100Mbps FDX , instead of a device running NWAY, it may

result in the devices connecting in HDX mode, this may cause packet

collisions on your network.

Please ensure that all network nodes that this device connects to are

set to the same mode at each end of the link.

e.g., Both ends are set to Auto-Negotiation mode (AUTO)

10. Cable Distances and Limitations

TP Cable Limitations: Cat 5 up to 100m

Fibre Cable Limitations:

SC/ST Converter Models

Multi Mode Half Duplex

Multi Mode Full Duplex

Single Mode Half Duplex

: If S1-1, S1-2, S1-3, S1-4 or S1- status is

changed, please press this button for your

settings to take effect.

: AUTO(Default) or FORCE

: 100 or 10 when TP at Force

: FDX or HDX when TP at Force

: LFP Enabled (Default) or Disabled

: 100FDX (Default) or 100HDX

: Enabled (Default) or Disabled

5/20/40/60/80/100Km

412m

2Km

412m