Dialogic IMG 1010 Installationsanleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Gateway Dialogic IMG 1010 herunter. Dialogic IMG 1010 6 Seiten. Connecting dc power
Auch für Dialogic IMG 1010: Schnellstart-Handbuch (11 seiten), Schnellstart-Handbuch (18 seiten), Schnellstart-Handbuch (10 seiten), Schnellstart-Handbuch (10 seiten), Installationsanleitung Handbuch (9 seiten), Schnellstart-Handbuch (4 seiten)

Re-insert Dialogic

IMG 1010 Motherboard Tray. Align the rail on each side of the tray with the

guides on the inside of the docking station.

Verify the ejectors are in the up position.

Slide the tray in until the power connectors and signal connectors initially mate (the ejectors will

start to move down).

Cautions:

Do not force the tray if any resistance occurs when mating with the docking station. Using undue

force could damage the unit.

The guides only provide gross alignment to the power and signal connectors. The guide pins on the

main board and I/O card are self-aligning and provide alignment for the connectors.

The tray guides also act as the conduit for any Electrostatic Discharge (ESD) as the tray initially

mates with the docking station.

When the tray is seated and the connectors are mated, push the ejectors down and tighten the

captive fasteners.

Switch the power to ON (1) at rear of docking station.

Configure Module. See Configuring Media or Configuring VoIP in the On-line Help Documentation

on the Dialogic Technical Support web site:

Diagram 1 - Removing Dialogic

Dialogic Corporation

Installing a Dialogic

1010 VoIP or Media Module

http://www.dialogic.com/manuals

IMG 1010 Motherboard Tray

Part # 07-8740-01

Page 5 of 6