Allpax SM4 Betriebsanleitung - Seite 7

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Kutter Allpax SM4 herunter. Allpax SM4 12 Seiten. Allen rotary-style gasket cutter

(Figure 10H) Assembly is the reverse of the previous steps.

NOTE: When assembling the top shaft assembly, the

washer assembly for the top cutter lifter bearing must be

assembled with a pin which lines up two washers and the

top cutter disc lifter bearing. Tighten this bolt so that mod-

erate resistance is felt when engaging and disengaging

cutting disc lever.

SHARPENING THE TOP CUTTING DISC FOR NON-METALLIC GASKETS

(Figure 12) Sharpen by holding a small, hand sharpening stone

to bevel side of the cutting disc. Slowly turn the hand crank. Then hold

the stone to the flat face to remove rolled edges or burrs.

NOTE: Sharpening the top cutting disc for metallic gaskets

is not recommended.

TOP CUTTING DISC REPLACEMENT

(Figure 11) Disengage cutting disc lever. Use spanner wrench

(included) and place into corresponding holes in top cutting disc. The

top cutting disc is loosened by holding spanner wrench and turning the

crank handle counter-clockwise. It may be necessary to give the crank

handle a sharp blow with the palm of your hand to initially loosen the

cutting disc. Place new or sharpened cutting disc onto top shaft and

tighten by holding with spanner wrench and turning crank handle

clockwise.

NOTE: Figure 11 shows crank direction for loosening top

cutting disc.