Dialogic D/4PCIUF Schnelle Installation - Seite 2

Blättern Sie online oder laden Sie pdf Schnelle Installation für Computer Hardware Dialogic D/4PCIUF herunter. Dialogic D/4PCIUF 2 Seiten.

Seite drucken

Installing the Hardware

NOTE: If you are adding Intel

hardware to an existing

system, you do not need to uninstall existing system software.

1. Working with your computer at a static-safe work area,

switch off the power and disconnect all power cords

from the electrical outlets.

2. Remove the computer cover.

3. Select an empty PCI expansion bus slot and remove the

slot's retaining screw and access cover plate.

4. Insert the edge connector of the board into the bus slot.

Press firmly until the board is securely seated.

Installing the Universal PCI Board

Remove

Cover

Plate

Computer

Chassis

PCI Slot

ISA Slot

5. Replace and tighten the retaining screw to secure the

board firmly in the chassis slot.

6. Replace the computer cover when finished and

reconnect the power cords.

7. Turn the power to the chassis ON.

CAUTION: If your BIOS is set to use Plug and Play

technology and there are ISA boards in your system, an

IRQ conflict can be created if a PCI board is assigned the

same IRQ as an ISA board. This could cause the machine

to stop responding. You can prevent this by entering the

BIOS and reserving the appropriate IRQs (those used by

your ISA boards) for ISA use only.

Connecting External Cables

Each RJ-11 jack on the rear bracket of this board supports a

single channel. Use RJ-11 connectors and telephone cable to

connect each channel jack to a PBX station port or to the

Public Telephone Network Central Office (CO).

NOTE: A standard telephone will not function when directly

connected to the board.

Connecting Cables to J1-J4

Pinouts for J1–J4

on Bracket

PCI

UNUSED

Board

UNUSED

Ring

Tip

UNUSED

After Installing the Hardware

After installing the hardware, proceed with the system

software installation as described in the system software

documentation (if applicable).

When configuring your system using the DCM configuration

tool, the correct menu selection to choose is "D4PCIU"

regardless of whether you are using a D/4PCIU or D/4PCIUF

board. Both boards share the same product family name in the

DCM tool.

For technical specifications and product information, see the

Intel

website at

http://www.intel.com/design/network/products/telecom.

Authorization (DRA) Process

If you are a reseller and are located in the Americas, you may

return a board for warranty repair by using the online form at

http://www.intel.com/support/motherboards/draform.htm. For

all other returns, contact your vendor or Intel Customer

Support (see http://www.intel.com/support/9089.htm).

PBX or Public Telephone

Network Cable Connector

Pin 1

NOTE:

J1 is Channel 1

J2 is Channel 2

J3 is Channel 3

J4 is Channel 4

Direct Return