Dialogic DM/V480A-2T1-PCI Schnellinstallationskarte - Seite 2

Blättern Sie online oder laden Sie pdf Schnellinstallationskarte für Computer Hardware Dialogic DM/V480A-2T1-PCI herunter. Dialogic DM/V480A-2T1-PCI 2 Seiten. Media board

Seite drucken

the board.

5. Using the slot's board guides, insert the board's edge

connector into the bus slot. Press firmly until the

board is securely seated in the slot.

Installing a PCI Board

Remove

Cover

Plate

Computer

Chassis

32-Bit

PCI Slot

6. Replace and tighten the slot's retaining screw to

secure the board firmly in the chassis (if applicable).

7. Connect external digital telephone cables to the

RJ-48C jacks on the board bracket. The topmost

RJ-48C jack is for trunk 1 and the second RJ-48C

jack is for trunk 2.

Pinouts for the RJ–48C

Network Interface

Jacks on Bracket

Cable Connector

RCV_RING

Pin 1

RCV_TIP

CHASSIS GROUND

XMIT_RING

XMIT_TIP

CHASSIS GROUND

8. Repeat steps 3-7 for each additional board you are

installing.

9. Use the CT Bus cable to connect the board(s) you

are installing to other boards in the system. To

preserve the electrical integrity of the CT Bus, use a

CT Bus cable with the appropriate number of

connectors ("drops"). It is recommended that no more

than two connectors at either end of the cable be left

unused.

Note:

10. Your system may include both CT Bus and SCbus

boards. To connect both board types, you must

install a CT Bus/SCbus Adapter on one of the CT

Bus boards in a system. See the CT Bus/SCbus

Adapter Quick Install Card for installation details

about the Adapter and the bus cables.

11. Install CT Bus Termination Jumpers only on boards

located at each end of the CT Bus cable. See the

"Physical Description" section for jumper details.

Installing the CT Bus Cable

PCI

Board

12. Replace the computer's cover when finished and

reconnect the power cords.

16-Bit

ISA Slot

13. Turn the computer's power ON.

CAUTION: If your BIOS is set to use Plug and Play

technology and there are ISA boards in your system, an

IRQ conflict can be created if a PCI board is assigned

the same IRQ as an ISA board. This could cause the

machine to stop responding. You can prevent this by

entering the BIOS and reserving the appropriate IRQs

(those used by your ISA boards) for ISA use only.

After Installing the Hardware

After installing the hardware, run the Dialogic

Configuration Manager (DCM) as described in the

installation instructions included with the Dialogic

System Software to configure your system.

For technical specifications and product information go

to: http://www.dialogic.com/products.htm.

Warranty and Return Information

For specific warranty information for this board, refer to

the Warranty section of the Products page, located at

this URL: http://www.dialogic.com/warranties/.

Dialogic provides technical support for its products

through a network of value added distributors who are

trained to answer technical questions on installing and

configuring Dialogic

to contact your support channel, please call Dialogic

in the United States at 973-967-6600 (9am-5pm EST)

and we will assist in obtaining the appropriate support

channel. Outside the United States please refer to

http://www.dialogic.com/support/contact

local contact information. Dialogic also provides direct

support via Dialogic

CT Bus

Colored

Cable

Stripe

(Pin 1)

Note:

Your CT Bus cable may

have a different number

of connectors (drops).

Warranty Period

Contacting Technical Support

products. If you are unsure how

to obtain

Pro™ Services agreements. For

more details of direct support from Dialogic please refer

to: http://www.dialogic.com/support/DialogicPro.

Returning a Product

To return a board for warranty repair or any other

returns, please refer to the following:

http://www.dialogic.com/support/hwfaults .

Sales Assistance

If you have a sales question, please contact your

local Sales Representative or the Regional Sales Office

for your area. Address, telephone and fax numbers, are

available at the Dialogic website located at:

http://www.dialogic.com/contact.htm

To purchase Dialogic

following website to locate the appropriate supplier:

http://www.dialogic.com/purchase.htm

All contents of this document are furnished for informational use only and are subject

to change without notice and do not represent a commitment on the part of Dialogic

Corporation or its subsidiaries ("Dialogic"). Reasonable effort is made to ensure the

accuracy of the information contained in the document. However, Dialogic does not

warrant the accuracy of this information and cannot accept responsibility for errors,

inaccuracies or omissions that may be contained in this document.

INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION WITH

DIALOGIC

PRODUCTS. NO LICENSE, EXPRESS OR IMPLIED, BY ESTOPPEL

OR OTHERWISE, TO ANY INTELLECTUAL PROPERTY RIGHTS IS GRANTED

BY THIS DOCUMENT. EXCEPT AS PROVIDED IN A SIGNED AGREEMENT

BETWEEN YOU AND DIALOGIC, DIALOGIC ASSUMES NO LIABILITY

WHATSOEVER, AND DIALOGIC DISCLAIMS ANY EXPRESS OR IMPLIED

WARRANTY, RELATING TO SALE AND/OR USE OF DIALOGIC PRODUCTS

INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS FOR A

PARTICULAR PURPOSE, MERCHANTABILITY, OR INFRINGEMENT OF ANY

INTELLECTUAL PROPERTY RIGHT OF A THIRD PARTY.

Dialogic products are not intended for use in medical, life saving, life sustaining,

critical control or safety systems, or in nuclear facility applications.

It is possible that the use or implementation of any one of the concepts, applications, or

ideas described in this document, in marketing collateral produced by or on web pages

maintained by Dialogic may infringe one or more patents or other intellectual property

rights owned by third parties. Dialogic does not provide any intellectual property

licenses with the sale of Dialogic products other than a license to use such product in

accordance with intellectual property owned or validly licensed by Dialogic and no

such licenses are provided except pursuant to a signed agreement with Dialogic. More

detailed information about such intellectual property is available from Dialogic's legal

department at 9800 Cavendish Blvd., 5

Dialogic encourages all users of its products to procure all necessary intellectual

property licenses required to implement any concepts or applications and does not

condone or encourage any intellectual property infringement and disclaims any

responsibility related thereto. These intellectual property licenses may differ from

country to country and it is the responsibility of those who develop the concepts or

applications to be aware of and comply with different national license

requirements.

Dialogic, Diva, Eicon, Eicon Networks, Eiconcard and SIPcontrol, among others, are

either registered trademarks or trademarks of Dialogic. Dialogic's trademarks may be

used publicly only with permission from Dialogic. Such permission may only be

granted by Dialogic's legal department at 9800 Cavendish Blvd., 5th Floor, Montreal,

Quebec, Canada H4M 2V9. Any authorized use of Dialogic's trademarks will be

subject to full respect of the trademark guidelines published by Dialogic from time to

time and any use of Dialogic's trademarks requires proper acknowledgement. The

names of actual companies and products mentioned herein are the trademarks of their

respective owners.

products, please refer to the

Floor, Montreal, Quebec, Canada H4M 2V9.