Miller AMD-4GH Benutzerhandbuch - Seite 17
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schweißen System Miller AMD-4GH herunter. Miller AMD-4GH 24 Seiten.
Auch für Miller AMD-4GH: Benutzerhandbuch (28 seiten)
Seite drucken
SECTION 4 − MAINTENANCE AND TROUBLESHOOTING
4-1. Routine Maintenance
Replace
Cracked
Parts
OR
4-2. Brush Inspection And Replacement
3
2
Tools Needed:
Y Disconnect power before maintaining.
Replace
Unreadable
Labels
Cord
Blow Out Or
Vacuum Inside.
During Heavy
Service,
Clean Monthly
Return To Table Of Contents
3 Months
Repair Or
Replace
Cracked
Weld
Cable
Gas
Hose
6 Months
1
1/4 in (6 mm)
Minimum Length
5/8 in (16 mm)
New Length
Replace
Damaged
Brushes
Clean
And
Tighten
Weld
Terminals
Gun
Cable
Clean
Drive
Rolls
1
Motor
2
Brush Cap
Remove brush cap.
3
Brush
Replace brush if it becomes
chipped or broken, or if less than
1/4 in (6.4 mm) of brush material is
left. Do not include spring boss as
part of the 1/4 in measurement.
Install brush so that curved surface
on end of brush matches curve of
motor, and secure with cap.
Repeat procedure for other brush.
137 390-C / S-0816
OM-179 082 Page 13