Miller Coolmate 3.5 CE Benutzerhandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schweißen System Miller Coolmate 3.5 CE herunter. Miller Coolmate 3.5 CE 20 Seiten.

5-2. GTAW Connections

Do not move or operate unit where

it could tip.

To prevent overheating, make sure cooling

unit is positioned so airflow is not restricted.

NOTICE − If welding power source has a

water valve, do not connect hoses to water

valve. Connect hoses as shown.

Coolant Out Hose

Coolant In Hose

A complete Parts List is available at www.MillerWelds.com

Fittings have 5/8-18 left-hand threads.

Connect hoses with proper fittings as

shown. Some power sources may require

a TIG block.

Coolant Tank Cap

115 Volt AC Grounded Receptacle

An individual branch circuit capable of car-

rying 15 amperes and protected by fuses

or circuit breakers is recommended. Rec-

Tools Needed:

5/8 in.

Ref. 804846-C

ommended fuse or circuit breaker size is

15 amperes.

Operation:

Fill tank with proper coolant. Use table in

Section 4-3 to select proper coolant. Main-

tain coolant level at approximately 1 in (25

mm) below top of filler neck. Connect

hoses as shown. Unit turns on when

plugged in.

OM-231313 Page 9