Diametral AC250K1D-S Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Handbuch für Stromversorgung Diametral AC250K1D-S herunter. Diametral AC250K1D-S 12 Seiten. Ac power supply

you will return back to the normal operation mode of the power supply.

V.V. Controlling via parent computer

Connect the AC Power Supply with using the supplied serial cable to the serial port of the

computer (COM1 or COM2). Do not use any other serial cable than the one supplied together

with the source - otherwise you can damage the power supply or computer!

Install the controlling software D-View AC1. Than follow the hints in D-View AC1.

WARNING:

The communication is operational only if this communication is allowed - see the Chapter V.IV.

Successful communication is signalized also by indicators Rx and Tx placed on the backward

panel of the source behind the connector CANNON.

VI. Change of the safety fuse

The AC power supply is equipped with two safety fuses. The safety fuse placed on the

backward panel of the power supply protects the whole equipment. The fuse placed on the

forward panel protects the power supply output against the short circuit.

FIRST BEFORE CHANGING THE SAFETY FUSE DISCONNECT THE POWER

SUPPLY BY PULL-OFF THE FLEX CABLE FROM THE SOCKET OUTLET!

Screw out the cover of the safety case with using a screwdriver, take out the safety fuse and

put inside the new one. Always make sure that the new safety fuse has the value mentioned

in the technical parameters! (see the Chapter II). Then screw in the cover of the safety case

back with using the screwdriver again. If the safety fuse is sublimed repeatedly, please send

the product to a service for repairation.

WARNING:

Never use stronger safety fuse than is mentioned in the Instruction Manual!

VII. Trouble Shooting

PROBLEM

No control light is lighting, the power supply

is not working

Even though the AC Power Supply is

powered from the mains and the mains

switch is in the position ON, the displays are

not lighting and the source is not operating.

- 8 -

SOLUTION

Put the power flex cable in the socket outlet

230V/50Hz and switch on the switch of

mains.

The safety fuse is sublimated. Change it

according to the Chapter VI. of this manual.

Pay attention to the right value!