aquantica at2i Betriebshandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Kamera-Zubehör aquantica at2i herunter. aquantica at2i 16 Seiten. For the canon t2i

With the camera inside the housing, push the lens release lever (key # 12) into the proper position, install the lens

prepared with the gears through the port opening in the front of the housing. Ensure that the lens mounted gears are

properly installed and aligned. Rotate the focus / zoom control knob to ensure that the gears are properly meshed, do not

grind and that their rotation is smooth.

Note: To avoid damaging the auto-focus mechanism of the camera when using standard EF type lenses, you should

always set the Focus Control to "M" Manual for testing the proper meshing of a focusing gears. this procedure is not

required with USM type lenses.

CHANGING A LENS (REMOVING A LENS)

Two differents methods can be used for removing/replacing a lens.

The lens mounted gears may restrict the view and ease of access to the lens release button on the camera body. The

AQUATICA T2i / 550D Digital Housing features a lens release lever (key # 12) that is designed to access the lens release

button of camera to allow easy removal of lens.

To remove a lens, remove the port, simply rotate Lens Release Lever (key # 12) to press the camera body lens release,

hold and turn the lens to remove.

Or pull out the lens release lever (key # 12) and Focus / Zoom knob assembly (key # 08) out of the way by rotating the

disk (key # 09), open the back cover, if using wired connectors then remove the hot shoe from the camera and pull out the

complete camera with its lens, replace the lens and reinstall.

MOUNTING THE PORT

Before mounting the Port on the Housing always ensure that the port O-ring is clean, lubricated and properly seated in its groove and that he sealing

surface on the Housing is clean and free of physical damage.

The AQUATICA T2i / 550D Digital Housing features a locking bayonet mount (#14). To mount the port or extension ring simply:

Place the housing on its back on a soft steady surface. inspect the sealing

surface of the housing to ensure it is clean and free of debris

Place the port or extension ring with a clean and freshly lubricated O-ring inside

the main port of the housing. Align one of the four alignment notches with the

opening of the housing.

Place your hands on opposite sides of the port or extension ring.

Push with even force on both sides of the port or extension ring until you feel it

snap into place. Make sure the bayonet is completely inside the housing.

Finally press the port lock button down, turn the Port clockwise until it stops and

then release the port lock button. Do not force it. If there is too much resistance

take the port off, check the O-ring and retry.

Check to ensure for the proper seating and sealing of the port or extension and that it is

safely locked on the housing.

Note : It is recommended that you familiarize yourself with this mount by trying it without the

camera, this will allow you to see the inside view of the bayonet mount and of the ports or

extension rings in the housing.

LENS INSTALLATION

page 8