Miller GA-60CF Benutzerhandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör für das Schweißen Miller GA-60CF herunter. Miller GA-60CF 24 Seiten.

6-2.

TROUBLESHOOTING

TROUBLE

Flux stops flowing while

welding.

Flux blows out of gun.

OM-1542 Page 8

PROBABLE CAUSE

Restricted flux feed hose.

Restricted air hose or no air

supply to flux tank.

Pressure setting too low.

Flux chunks.

Wet or damp flux

Extended flux hose.

Pressure setting too high.

Clogged air vents in gun

nozzle.

REMEDY

Check flux hose and remove any kinks or ob-

structions.

Check air hose and remove any kinks; check

air supply to flux tank.

Readjust regulator pressure, and check flux

flow according to Section 3-6.

Remove flux from tank, and sift through 0.062

in (1.57 mm) mesh according to Section 3-5.

Remove flux from tank, and replace with dry

flux according to Section 3-5.

Readjust regulator pressure, and check flux

flow according to Section 3-6.

Readjust regulator pressure, and check flux

flow according to Section 3-6.

Clean air vents with compressed air.