Miller Maxstar 161 STL Benutzerhandbuch - Seite 33

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör für das Schweißen Miller Maxstar 161 STL herunter. Miller Maxstar 161 STL 44 Seiten. Arc welding power source with auto-line

Seite drucken
Miller Maxstar 161 STL Benutzerhandbuch

8-3. Troubleshooting

Trouble
No weld output; unit completely
inoperative.
No weld output; unit on.
Unit provides only maximum or
minimum weld output.
Erratic or improper weld output.
No control of weld output.
Lack of high frequency; difficulty in
starting GTAW arc.
Wandering arc − poor control of
direction of arc.
Tungsten electrode oxidizing and not
remaining bright after conclusion of
weld.
Fan not operating.
No weld output; fan does not run.
No weld output; fan on.
Fan not operating; weld output
available.
Error message [See O.M. ERROR
3.4.1] is displayed.
Error message [See O.M. ERROR
3.3.1] is displayed.
Error message [See O.M. ERROR
7.2.3] is displayed.
Error message [See O.M. ERROR
1.4.0] is displayed.
.
A complete Parts List is available at www.MillerWelds.com
Place line disconnect switch in On position (see Sections 5-4 or 5-5).
Check and replace line fuse(s), if necessary (see Sections 5-4 or 5-5).
Check for proper input power connections (see Sections 5-4 or 5-5).
Check, repair, or replace remote control.
Have Factory Authorized Service Agent check unit.
Make sure Material Amperage control is in proper position (see Section 6-1).
Have Factory Authorized Service Agent check unit.
Lay weld cables out straight, do not leave weld cables coiled.
Check position of Process Selector switch (see Section Figure 6-1).
Check position of Amperage control (see Section 6-1).
Make sure Material Amperage control is in proper position (see Section 6-1).
Be sure torch cable is not close to any grounded metal.
Check cables and torch for cracked insulation or bad connections. Repair or replace.
Reduce gas flow rate (see Section 6-1).
Properly prepare tungsten (see Section 11-2).
Shield weld zone from drafts.
Check and tighten all gas fittings.
Properly prepare tungsten (see Section 11-2).
Unit equipped with Fan-On-Demandt. Fans run only when necessary. Unit equipped with circuitry to
protect against overheating.
Place line disconnect switch in On position (see Sections 5-4 or 5-5).
Check and replace line fuse(s), if necessary, or reset circuit breaker (see Sections 5-4 or 5-5).
Check for proper input power connections (see Sections 5-4 or 5-5).
Check connection to remote control receptacle (see Section 4-7).
Check remote control (see remote control Owner's Manual).
Unit overheated. Allow unit to cool (see Section 4-5).
Check for and remove anything blocking fan movement.
Have Factory Authorized Service Agent check fan motor.
Contact a Factory Authorized Service Agent.
Contact a Factory Authorized Service Agent.
Contact a Factory Authorized Service Agent.
Contact a Factory Authorized Service Agent.
Remedy
OM-275099 Page 29