Miller Spoolmatic 30A Benutzerhandbuch - Seite 21
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör für das Schweißen Miller Spoolmatic 30A herunter. Miller Spoolmatic 30A 32 Seiten. Welding guns
Auch für Miller Spoolmatic 30A: Benutzerhandbuch (36 seiten), Benutzerhandbuch (32 seiten)
Seite drucken
5-3. Gun Drive Assembly Maintenance
3
1
Tools Needed:
5/16 in
2
4
Retract wire onto spool.
1
Setscrew
2
Current Pick-Up Tab
This tab helps prevent burnback
caused by welding arcs inside the
contact tip. This tab may be re-
moved to provide an insulated drive
roll. (If tab is removed, a smaller di-
ameter contact tip is recom-
mended. See options in Parts List.)
Lightly grease top of tab before rein-
stalling.
3
Drive Roll
Use wire brush to clean drive roll.
Install drive roll with desired groove
down, and turn drive roll so one set-
screw faces flat side of shaft.
4
Bearing
Use wire brush to clean bearing.
Line up drive roll groove with bear-
ing groove and liner opening. Tight-
en setscrews.
Thread welding wire through gun
(see Section 3-3). Close and se-
cure pressure roll assembly. Adjust
drive roll pressure, if necessary
(see Section 3-8). Reinstall top cov-
er.
Ref. 149 967-C / Ref. 800 945-A
OM-1213 Page 17