Miller Spoolmatic 30A Benutzerhandbuch - Seite 19

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör für das Schweißen Miller Spoolmatic 30A herunter. Miller Spoolmatic 30A 32 Seiten. Welding guns
Auch für Miller Spoolmatic 30A: Benutzerhandbuch (32 seiten), Benutzerhandbuch (36 seiten)

Seite drucken
Miller Spoolmatic 30A Benutzerhandbuch

7-4. Replacing Canister Inlet Guide

3
Tools Needed:

7-5. Replacing Spool Canister

4
3
Tools Needed:
1
2
1
2
7
6
5
4
8
5
1
Top Cover
2
Pressure Roll Assembly
Cut off welding wire where it enters
pressure roll assembly area.
3
Nozzle
Pull wire out nozzle.
4
Thumbscrew
5
Canister Cover
Loosen thumbscrew and remove
cover.
6
Wire Spool
7
Spool Brake Thumbnut
Loosen thumbnut, retract wire onto
spool, secure, and remove spool.
8
Canister Inlet Guide
Turn counterclockwise to remove.
Install new guide.
Reinstall spool and thread welding
wire (see Section 5-2).
Close pressure roll assembly. Ad-
just spool brake pressure and drive
roll pressure if necessary (see Sec-
tion 5-7).
Reinstall covers.
Ref. 150 436-D / Ref. 149 967-H
1
Top Cover
2
Pressure Roll Assembly
Cut off welding wire where it enters
pressure roll assembly area.
3
Nozzle
Pull wire out nozzle.
4
Thumbscrew (Canister
Rotation)
Turn thumbscrew counterclock-
wise three full turns.
5
Spool Canister
Remove as shown. Push new can-
ister into wire drive housing until ful-
ly seated. Tighten thumbscrew.
Install spool and thread welding
wire (see Section 5-2).
Close pressure roll assembly. Ad-
just spool brake pressure and drive
roll pressure as necessary (see
Section 5-7).
Reinstall covers.
Ref. 149 967-H
OM-1213 Page 15