AquaOne CET Series Gebrauchsanweisung - Seite 14
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Water Pump AquaOne CET Series herunter. AquaOne CET Series 15 Seiten. Variable frequency pump with control
Seite drucken
1. Rotating remove the filter case as pic l,pic 2 is showed when finished.
2. According to the direction of the arrow showed in pic 3, push the insurance
clasp,rotating remove the impeller chamber, pic 4 is showed when finished.
3. Remove the rotor combination as pic 5, then you can clean or change.
4. The installation position of the O-ring as pic 6.
lf the pump is not used for a long time,please pull out the pump,it is better to run
the pump in the clean water for a short time.And then rinse with clean water.Clean
and make sure the pump is dry,put it in a stable place. lf the temperature is below
0 degrees,the water in the pump should be disch -arged immediately.ln order to
prevent freezing damage of water pump.
Troubleshooting
Malfunction
Pump do not run
Pump noise
Pump water shortage
www.aquaristikwelt24.de
Cause
• No power supply
• Burning machine
• lmpeller stall
• Run without water
• Not connected with
the controller
• The controller is
damaged
Dirty inside or Shaft break
•
•
Ceramic shaft wear
• Damage
of
impeller
• lnlet
and
outlet
obstruction
• Filter case obstruction
• Under voltage
Solving measures
• Connect power
• Change pump
• Clean and relink to power
• Fill with water and relink to
power
• Relink the controller
• Chanae the controller
Clean pump or change rotor
•
and ceramic shaft
the
• Change rotor combination
• Clean and relink to power
• Adjust the voltage
By Aquaristikwelt24
S e i t e
14