Chromalox DTS-HAZ Installationsanleitung Handbuch - Seite 5
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Thermostat Chromalox DTS-HAZ herunter. Chromalox DTS-HAZ 12 Seiten. Microprocessor based temperature control and power connection kit
Seite drucken
Cable installation instructions: SRL, SRM/E, SRP
CWM cable special instructions denoted by *
WARNING: For pipe temperatures over 500˚F (260˚C) or use with MI cable, use High Temp Adapter Kit
1. Insert heating cable through
pipe standoff and proper grom-
met as shown. 8 inches of cable
should extend past the grom-
met. Strap pipe standoff to pipe
with pipe strap (Chromalox type
PS not included) and attach ex-
tra cable to pipe as appropri-
ate. If the provided RTD is to be
fed through the standoff pipe, a
small slice will need to be made
to the outer edge of the top of
the grommet. For pipes smaller
than 1-1/2" diameter a small
pipe adapter (Chromalox model
SPA not included) is required.
4. While bending the heating ca-
ble, work the cable through the
braid opening. Pull the braid
tight.
2. Score the outer insulation 7
inches from the end of the cable.
Lightly cut the outer jacket up
the center to the end of heating
cable and remove the outer jack-
et from the cable. WARNING:
DO NOT CUT METAL BRAID.
Note: If using over braid only
cable, skip this step.
5. Score the inner insulation 6 inch-
es from the end. Lightly cut the
inner jacket up the center to end
of heating cable and remove the
inner jacket from the cable.
5
3. Move braid back toward the
overjacket, creating a bulge. At
the bulge, separate the braid to
make an opening.
6. Use tin snips or similar tool to
cut excess material from be-
tween the buss wires.
*Separate CWM leads and strip
1/4" from each lead wire.