Aquaox OXL5600-8 Schnellstart-Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Water Filtration Systems Aquaox OXL5600-8 herunter. Aquaox OXL5600-8 6 Seiten.

8. Make sure both cutoffs (A) and (B) are in the OFF position.

9. Install a garden hose to the hose bib and run the hose either outside or into utility sink/open drain.

10. Place the hose bib valve to the ON position.

11. Make sure that the bypass valve is in the SERVICE position, and slowly turn on cutoff (A).

12. Fill the tank slowly so not to disturb the media bed. NOTE: the water flowing from the hose is cloudy and/or

contains media fines as well as air.

13. When steady flow comes from the hose, TURN OFF hose bib and cutoff (A) and allow the media bed to

soak & settle for 30 minutes. Note: 30 minutes is minimal requirement. Longer is better 45-60 minutes.

Typically this is done while the backwash pipes are being assembled and positioned to drainage.

14. During pre-soak, attach the backwash piping to empty into the drain line. Install to code for your area.

15. Makes sure the hose bib is in the off position and the bypass valve is in the IN SERVICE position.

16. Turn cutoff (A) to the ON position.

17. The system is now ready to run through the backwash cycle.

18. Plug in the power cord.

19. Set the time by pushing down and holding the down arrow for 3 seconds. This will put it in clock mode. Set

the time by pressing the up or down arrows until you have the correct time displayed and press the next

button at the bottom left once to lock in the time.

20. The time should be displayed on the screen.

21. There will be a number "3" that will flash up. That is just the number of days until the next backwash.

22. Now you are ready for the initial backwash. Press the regeneration button and hold for 3 seconds. This will

take around 20 minutes. NOTE: backwashing regularly is absolutely vital to the performance of this water

system.

23. When the wash is complete, the time will display.

24. Turn the hose bib back on and let the water run until it is clear. We recommend that you run water into a 5

gallon white bucket to insure the clarity of the water before you run it into the house.

25. When the water is clear, turn off the hose bib and turn cutoff (B) to the ON position.

26. Remember that the hot water tank has old water in it. It may take up to a week to replace the old water with

purified water.

INSTALLATION QUESTIONS? CALL (855) 826-1130 OR VISIT HTTPS://WWW.AQUAOXFILTERS.COM