Aquaport AQP-WCS Installations- und Betriebsanleitung - Seite 9
Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Wasserspender Aquaport AQP-WCS herunter. Aquaport AQP-WCS 12 Seiten. Executive water cooler cold and room
Seite druckenTROUBLE SHOOTING
BEFORE YOU CALL FOR SERVICE PLEASE REVIEW THE TROUBLE SHOOTING TIPS FIRST.
Problem
Possible Causes
1. Unit is not plugged into the wall socket.
No Power
2. Power switch at rear of unit is turned off.
3. Fuse has blown.
1. Unit is not plugged into the wall socket.
2. Power switch at rear of unit is turned off.
Not Cooling
3. Unit may have been laid down during
transport.
Water is leaking.
*99% of leaks
1. Pin hole in spring water bottle.
that may occur
2. Faulty float valve on filter bottle.
with this unit are
3. Tap is not installed correctly.
caused by the
bottle used with
4. Loose hose connection.
the water cooler*
What To Do
1. Check connection to wall socket.
2. Turn unit on from rear power switch.
3. Replace with new fuse.
1. Check connection to wall socket.
2. Turn unit on from rear power switch.
3. If the unit has been laid down during transport, keep the unit up
right for 48 hours before turning on. If still not cooling call customer
service on 1300 764 325.
1. Pin hole leaks are common when using polycarbonate spring water
bottles. The bottle supporter of the Executive Water Cooler is fitted
with a non-spill valve which will stop the water cooler leaking if a
spring water bottle has a pin hole. However it is highly recommended
that the spring water bottle is replaced and the fault reported to the
spring water supplier.
2. Float valve on filter bottle is not shutting off, contact filter bottle
supplier for replacement float valve.
3. Ensure the tap in screwed onto the water cooler tightly.
4. Call customer service on 1300 764 325.
INSTALLATION AND OPERATING INSTRUCTIONS 7