AquaPower AP23RP Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schwimmbad-Filter AquaPower AP23RP herunter. AquaPower AP23RP 16 Seiten. Aquapower salt water chlorinator

Seite drucken

CONTROL PANEL BUTTONS

MODE BUTTON:

Press to select ON, OFF or AUTO operation. (When

AUTO mode is selected, the ON/OFF times you have set

will switch both pump and chlorinator on and off on a daily

basis.)

OFF MODE:

Indicated by way of the anti-clockwise rotation of the top

portion of the ﬁrst digit.

Neither pump or chlorinator will operate.

ON MODE:

Indicated by way of the clockwise rotation of the top

portion of the ﬁrst digit.

Pump and chlorinator will operate continuously.

AUTO MODE:

Indicated by way of the clockwise rotation of the lower

portion of the ﬁrst digit. While in the auto mode and

during an OFF time period, the display will alternate from

displaying OFF to displaying the next ON time. This

feature allows for an easy visual of when the unit will next

switch on.

VIEW BUTTON:

Press repeatedly to display, current time, %chlorine output

and all four ON/OFF periods. All values remain displayed

for 30 sec, the normal real time %chlorine output is then

displayed.

Current 24hr. time is displayed.

% Chlorine output, is displayed. Use UP/Down buttons to alter time

ON1 is displayed, wait to see ON1 time. Use UP/Down buttons to alter time

OFF1 is displayed, wait to see OFF1 time. Use UP/Down buttons to alter time

ON2 is displayed, wait to see ON2 time. Use UP/Down buttons to alter time

OFF2 is displayed, wait to see OFF2 time. Use UP/Down buttons to alter time

ON3 is displayed, wait to see ON3 time. Use UP/Down buttons to alter time

OFF3 is displayed, wait to see OFF3 time. Use UP/Down buttons to alter time

ON4 is displayed, wait to see ON4 time. Use UP/Down buttons to alter time

OFF4 is displayed, wait to see OFF4 time. Use UP/Down buttons to alter time

Wiring instructions for AquaPower-Plus

Above Ground Units Only

All AquaPower-Plus above ground chlorinator systems are

set up to operate at 110 volt only. (If 220 volt system is

needed please contact Aquapower-Plus)

110 Volt Wiring ( No internal wiring is needed)

1. Plug supplied power cord attached to unit, into GFCI

protected circuit.

2. Plug your 110 volt pump into the receptacle located

on unit.

Wiring of unit is complete. You just have to set your

AquaPower timer to appropriate settings as indicated in your

owner's manual.